Summary of Contents for Tahoe 283
- Page 1 ANUAL G.703 / FastEthernet Interface Converter TAHOE 283 FREEDOM OF COMMUNICATION...
- Page 3 Introduction ® Tahoe 283 converter allows connecting of two LANs through an E1 line terminated with balanced G.703 interfaces. Converters work as transparent bridges, that is both interconnected networks appear as a single LAN, as if both were plugged into the same Ethernet switch.
-
Page 4: Ethernet Interface
Interfaces power power Ethernet G.703 connector switch Rear view of the converter 2.1. G.703 Interface The G.703 interface is equipped with a RJ-45 connector having following pinout: Signal RX + RX - TX + TX - The RX+ pin of the converter should be connected to the TX+ pin of the other device, the RX- pin to the TX- pin, TX+ to RX+ and TX- to RX- 2.2. -
Page 5: Technical Data
Status LEDs On the front panel there are four LEDs indicating device status: WAN Link - when lit, indicated synchronization to the other G.703 device WAN Act - blinks to signal the activity of the G.703 port LAN Link - when lit, indicates proper Ethernet connection between the converter and the switch or other device LAN 100M - when lit, indicates successful negotiation of 100 Mbps transfer rate on the Ethernet port... -
Page 6: Declaration Of Conformity
89/336/EEC EMC requirements 99/5/EEC radio & telecommunication terminal equipment requirements The compliance of Tahoe 283 with the requirements of the above mentioned directives is ensured by complete application of the following harmonized European Standards: EN 60950:2000 EN 55022:1998 EN 61000-6-1:2002... - Page 8 TAHOE ® Uniwersytecka 1 50951 Wroc³aw, Poland phone +48 50 100 7362 fax +48 71 344 2642 http://www.tahoe-group.com/...