Switching On/Off; Adjusting The Volume; Setting The Power-On Volume - Blaupunkt Key West MP38 Operating And Installation Instructions

Car stereo receiver
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

Switching on/off

Switching on/off
There are various ways of switching the de-
vice on/off:
Switching on/off with the On/Off button
u
For switch-on, press the On/Off but-
ton 6.
The device switches on.
u
To switch off the device, press and hold
down the On/Off button 6 for longer
than two seconds.
The device switches off.
Switching on/off using the vehicle
ignition
The device will switch on/off simultane-
ously with the ignition if the device is cor-
rectly connected to the vehicle's ignition as
shown in the installation instructions and
you did not switch the device off by press-
ing the On/Off button 6.
Switching the device off using the
detachable control panel
u
Detach the control panel.
The devices switches off after the time set
in the "OFF TIMER" menu.
Note:
To protect the vehicle battery, the de-
vice will switch off automatically after
one hour if the ignition is off.

Adjusting the volume

You can adjust the volume in increments
from 0 (off) to 66 (maximum).
To increase the volume,
u
turn the volume control 7 clockwise.
To decrease the volume,
u
turn the volume control 7 counter-
clockwise.

Setting the power-on volume

You can set the power-on volume.
u
Press the MENU•OK button 5.
u
Press the
or
edly until "ON VOLUME" appears on the
display.
u
button 4 to open the
Press the
menu item.
u
Set the desired power-on volume with
the button
or
To help you adjust the setting more easily,
the device will increase or decrease the vol-
ume as you make your changes.
If you set "LAST VOL" (setting 0 = LAST
VOL), the volume at which you were listen-
ing before power-off is activated again.
Note:
To protect your hearing, the power-on
volume is limited to the value "38" for
the setting "LAST VOL". If the volume
was higher before switch-off, the value
is automatically set to "38" at switch-
on. This prevents an unintentionally
and unexpectedly high volume when
switching on the device.
Volume
button 4 repeat-
4.
11

Advertisement

Table of Contents
loading

Table of Contents