GENERAL INFORMATION NOTES About the manual This manual contains information on installation, operation and maintenance of the equipment and must be consulted as a reference guide. Reading this book provides a safe and proper use of the appliance. In addition to the information provided with this manual, you must comply with local regulations.
NOTES WARNINGS BEFORE USE • Before using the appliance, please check that the voltage of the electricity grid corresponds to the one indicated on the label of the device. Only connect the machine to an outlet that has a minimum capacity of 10 A and an effective earthing system.
• Use only the supplied spatula to stir the preparations. TECHNICAL SPECIFICATIONS • Do not ever cook with the empty bowl. Power supply: 230V – 50 Hz • Never place the entire unit under the tap to introduce water into the bowl. Motor power: 1500 W •...
PLEASE NOTE! RECYCLING AND WASTE DISPOSAL In case you should bring the machine back to your dealer, please use exclusively the original package, as any break or fault caused by transport When the device stops working and must be scrapped, you must ensure that its damages due to lack of the original package could be charged to you.
IN THE CASE..PRODUCT DESCRIPTION The device does not turn on: - Check that the plug is inserted into the socket. - Check that the lid is closed completely, and there is no blinking icon on the display. The unit will stop automatically: - Verify that you do not have introduced excessive amounts compared to what the machine can accept and has not, thus leading to overheating as described above (see section “thermostat”).
MACHINE DEVICES CONTROL PANEL (7) Menu: to access to the recipe menu. + -: to increase or decrease Speed, Time Temperature parameters.. When “+” “- ” are used as pulse buttons, the parameters increase or decrease by one digit. If you keep pressing the buttons, the parameters will quickly increase or decrease, just depending on how long the buttons...
Page 10
Gauge (14) water, milk, etc.), you must keep in mind that over time the rice absorbs the liquid It is the element enabled to control the temperature set. and therefore the cooking time should be reduced. • After cooking, wait a moment before opening the lid and take care of possible LIQUID LEAKING HOLE (16) “puffs”...
• When cooking, never exceed the litre and half of ingredients (including liquids finish the recipe, before involving the static thermostat. When the dynamic and solids) otherwise you run the risk that the contents of the bowl could thermostat is in operation, the word “PULSE” will be displayed, and you can overspill.
Page 12
CAUTION: Before you start the appliance, please always check that the CAUTION: Never leave your appliance unattended during the two side flaps are closed. operations. CAUTION: Remove the seal periodically and clean the dirt between the It is possible to check if set data are correct when the machine is in seal itself and the cover.
Page 13
the display shows “- -: - -” with the first two lines that are flashing, they indicate CAUTION: The maximum capacity must never be exceeded, and it the hour, with the “” and “-” you could just set the time format 0-24. is vital that you take it into account for some foods such as leavened Once you have chosen the time, you have to store your data by pressing the dough (bread, pizza, etc..) During some preparations volume increases,...
CAUTION: After you have crushed harsh elements (ice, nuts, carrots etc.) • You will hear a beep ALWAYS tighten the locker. • Set a time of your choice WARNING: DO NOT put the blades in the dishwasher and do not use •...
• To confirm the new set data, select YES with the “+” and “-” buttons, and CLEANING confirm by pressing the START button, then pass on to the next screen. • Conversely, if you do not want to confirm the new set data, select NO with the Clean the appliance with a damp cloth and neutral detergent, avoid cleaners “+”...
Page 16
• On the next screen the indication “OPERATION COMPLETED” will appear. It WARNING: at the first use, it is possible that the device emit a low noise, will mean that all the necessary operations have been set. The indication will due to the internal stabilization of the joints.
Page 17
B. From the PC, after inserting the SD card into the appropriate card reader, • The range of time varies from 5 seconds to 4 hours. through the program into the Hotmix file it is possible to store number and name •...
Page 18
TURBO WORK: of a specific recipe), and the name and the quantity of the first ingredient. Within When the unit is operating with the trend of the regular program: some programs, neither the ingredients not the quantities are being specified. •...
Need help?
Do you have a question about the HOTMIX PRO GASTRO and is the answer not in the manual?
Questions and answers