Replacing The Pen Tip; Installation; Attach The Main Unit; Attach The Pen Stand - Pioneer pdk-50hw2a Operating Instructions Manual

<Replacing the Pen Tip>
The accessory pen tip is made of felt. If the tip becomes
deformed and writing quality deteriorates, replace the tip
with one of the supplied extras.
1. Pull out the felt tip.

INSTALLATION

<Attach the Main Unit>
NOTES:
÷ Always install the plasma display on a mobile cart before
installing this unit.
÷ After installing this unit, never attempt to lift the plasma
display to install on a mobile cart.
÷ When this unit is mounted to variable-angle Pioneer
Hung on Wall Unit PDK-5006 or PDK-5011, it cannot be
installed in a tilting position.
÷ If the need arises to move the unit after it is installed on
a mobile cart, take care not to apply pressure on the unit
when moving. Always lift by the mobile cart when
moving.
1. Remove the "Pioneer" emblem from the
plasma display.
The emblem is affixed with two-sided tape (aligned with
two guide pins). Remove the emblem so that no tape
remains.
The unit will not operate
properly if the emblem is
not removed.
2. Place the unit over the front of the plasma dis-
play.
NAME AND FUNCTION OF PARTS
CAUTION:
If you continue using a pen with a damaged or worn felt tip,
the monitor screen may be damaged.
2. Insert a new felt tip.
Press the felt tip into the pen so that about the tip is
exposed by about 2 – 3 mm.
3. Use the locking fixture on the rear panel to se-
cure the four corners of the unit.
1 Rotate the locking fixture in the direction indicated by
the arrow (rotate in the opposite direction for the left-
side fixture), to secure the unit in place.
2 Press in the locking fixture's stopper to prevent the
fixture from moving.
Locking fixture
<Attach the Pen Stand>
7 Use the furnished Allen bolt to fasten the pen
stand in place to the rear side of the unit.
Rear side of unit
Pen stand
÷ Hold the pen stand upright and against the bottom of
the unit when inserting the Allen bolt.
2~3mm
Stopper
Allen bolt
19
En