Prepare The Plasma Tv; Attaching/Fastening Plasma Tv; Removal - Panasonic TY-WK42PR2W Fitting Instructions Manual

4. Prepare the plasma TV

Fit the insulation spacers to the plasma TV.
Place the plasma TV unit face down on a blanket or other soft cloth that is clean and free of debris, and follow the procedure
below.
( 1 ) Remove the terminal cover on the plasma TV
( PA30, PE30, PV30 series only ) .
( 2 ) Using a flathead screwdriver, remove the four
caps from the plasma TV.
* Carefully retain the removed terminal cover and
caps in a safe place. ( They will be needed again
later should it be required to use the special-
purpose stand or standalone stand. )
( 3 ) Using the included Allen wrench, fit the included
Allen head countersunk screws, dished tooth
washers and insulation spacers ( 4 sets ) into the
holes from where the caps were removed. ( See
the diagram at right. )
Allen head countersunk screw
Dished toothed washer
Insulation spacer
Allen wrench
5. Attaching the plasma TV to the wall-hanging bracket and
connecting the wiring
(1) Remove the red screws for open/close fastening (one
each on the left and right )
( 2 ) Hook the insulation spacers on the top of the plasma TV
over the notches on the bracket, and allow the TV to
hang from the bracket.
( 3 ) Pull the plasma TV body forward, as shown in the diagram at
right, and connect the wiring.
( 4 ) After wiring is finished, slightly raise the plasma TV and
insert the insulation spacers at the lower back into the
holes at the base of the wall-hanging bracket.
( 5 ) Lower the plasma TV into place.
Notes
• If the plasma TV is raised too far, there is a
risk it may become unhooked from the top of
the bracket.
• Do not hold the front panel of a PA30, PE30,
PV30 Series plasma TV at the bottom.
6. Fastening the plasma TV
( 1 ) Fit the included fastening screws in the indicated holes
at the sides of the wall-hanging bracket ( left and right ) .
( 2 ) Securely refit the red screws for open/close fastening
( one each on the left and right )
on the sides of the wall-hanging bracket.
• Be sure to fit the fastening screws on the left
Note
and right to keep the plasma TV from falling
off the wall-hanging bracket.
Hole for red
screw for
open / close
fastening
Caps
.
in the indicated holes
Red screw for
1
open/close fastening
Wall-hanging bracket
Fastening screw
fitting position
Plasma TV
fastening screw
Flathead screwdriver
Terminal
cover
Top insulation Red screw for open /
1
spacer close fastening
2
Top notch
3
* Do not hold the bottom of the front panel.
7. Removal of plasma TV unit
( 1 ) Remove the screws for unit fastening ( 1 each
on the left and right ) that are fitted to the wall-
hanging bracket sides.
( 2 ) While lifting the bottom of the plasma TV unit,
pull it towards yourself.
( 3 ) When the lower insulation spacers are freed,
keep lifting upward.
( 1 ) Screw for plasma TV
unit fastening
Lower hole
4
5
Lower
insulation
spacer
( 3 )
( 2 ) Insulation spacer
5