Advertisement
Quick Links
Advertisement
Related Manuals for North Creek echo
Summary of Contents for North Creek echo
- Page 1 " # $...
- Page 2 & & & & Part (woofer) 2.20mH 16 AWG inductor 20.0uF Blue film capacitor 2.74 Ohm NORTH resistor (tweeter) 8uF Yellow film capacitor 0.56mH 16 AWG inductor 3.32 Ohm NORTH resistor 6.19 Ohm NORTH resistor (connectors, etc.) Big Ring Jr #10-10 AWG ring tongues large crimp barrels 0.25"...
-
Page 3: Required Tools
Required Tools: These are the basic tools required to complete this project. The items listed below are all available from MCM Electronics, www.mcmonline.com, 800-453-4330. The tools suggested are the least costly that will do the job. There are certainly better quality tools out there for considerably more money. The brands that seem to be the best are Xcelite, Ideal and Klein. - Page 4 With the label up, bend both leads straight down, then bend 1/4" of each end straight out (into an "L"). This method allows the legs to function both as the connectors and as the means of suspending the resistor body above the board. Please read the North Creek Wiring Guide, included with the kit package Woofer Network Assembly Closely inspect our crossover assembly diagram.
- Page 5 When everything cools down, drop three brass screws through the rear of the pegboard as indicated on the assembled crossover diagram. Flip the board over and drop the ring sections over the screws, attach with the nuts, tighten, and drop nail polish on the exposed threads. Shoot a little silicone under the capacitor and bind it and the inductor lead to the pegboard with a single tie wrap as shown on our diagram.
- Page 6 Tweeter Network Assembly Carefully inspect our assembled network diagram. This is a 4x5 board. "Attach" means "slide all leads into a single ring tongue crimping section, crimp, and solder Attach the stripped end of the 16" white wire to the gray leads of the 8uF Yellow cap with a single ring tongue Attach one 16"...
- Page 7 When everything cools down, shoot a little silicone under the capacitor and secure it and the buss bar/capacitor/inductor connection point with a long tie wrap. Make sure the buss bar is not touching any other connection, and coat it with silicone. Drop the inductor into place on the pegboard, loosely secure with tie wraps, add a little silicone under the inductor, tighten the tie wraps, trim excess Attach the inductor-blue wire ring tongue to the pegboard...
- Page 8 PO Box 1120 Old Forge NY 13420 www.NorthCreekMusic.com...