Table of Contents
Advertisement
®
xStack
DES-3810 Series Layer 3 Ethernet Managed Switch Hardware Installation Guide
CAUTION: Installing systems in a rack without the front and side stabilizers installed could cause the
rack to tip over, potentially resulting in bodily injury under certain circumstances. Therefore, always
install the stabilizers before installing components in the rack. After installing components in a rack, do
not pull more than one component out of the rack on its slide assemblies at one time. The weight of
more than one extended component could cause the rack to tip over and may result in injury.
DPS-800
The DPS-800 is a standard-size rack mount (1 standard unit in height) designed to hold up to two DPS-200 redundant
power supplies.
Figure 2–7 Installing the DPS-900 into the equipment rack
Figure 2–8 Installing the DPS-200 in the DPS-800
20
Advertisement
Table of Contents
