Standby Mode - Panasonic Viera TH-42PA60AC Operating Instructions Manual

Problem
Chaotic image, noisy
No image can be
displayed
Blurry or
distorted image
(no sound or low volume)
Neither image nor
sound is produced
No sound is produced
Sound level is low
or sound is distorted
Sound is unusual
An error message
appears
"Control with HDMI"
function does not work
TV unit goes into

"Standby mode"

An error message
appears
Actions
•
Set "D. PNR" in the Picture menu (to remove noise).
(p. 14)
•
Check nearby electrical products
(car, motorcycle, fl uorescent lamp).
•
Is "Colour" or "Contrast" in the Picture menu set to the
minimum? (p. 14)
•
Check "Colour system" (p. 16)
•
Reset channels. (pp. 9 and 16)
•
Is the unit in "AV mode"?
•
Is the mains lead plugged into the socket outlet?
•
Is the TV unit turned On?
•
Check Picture menu (p. 14) and volume.
•
Is "Sound Mute" active? (p. 7)
•
Is the volume set to the minimum?
•
Sound signal reception may be deteriorated.
•
Check "Sound system" (p. 16)
•
Set the sound setting of the connected equipment
to "2ch L.PCM".
•
Check the "HDMI input" setting in the Sound menu.
(p. 14)
•
If digital sound connection has a problem, select
analogue sound connection. (p. 26)
•
Contact the authorized Service Centre.
•
Switch the TV unit on again with the equipment on.
•
Set "Control with HDMI" to "Off", then set to "On" again.
(p. 20)
•
The sleep function is activated.
•
The TV unit enters "Standby mode" about 30 min.
after broadcasting ends.
•
Follow the message's instructions.
•
If the problem persists, contact the authorized
Service Centre.
29