3) Powering On WZB-05ET ………………………………...………………………………………………… 4 4) Configuring IP Address and Host PC Port for WZB-05ET……….……………………….……… 4 5) Enabling WZB-05ET to Permit Join Other Devices to its Network …………………..6 6) Removing WZB-05ET from the Parent’s Network …………………………………….………… 7 7) WZB-05ET LED Status …………………………………………………………….…………………….…….
WZB-05ET User’s Manual Congratulations for choosing a world-class digital temperature and humidity sensor using ZigBee wireless transmission technology. This manual is designed to help set up and get the most from the sensor in a few short minutes. Safety notice: Please read and follow the instructions before using this product ...
(if not using wall plugs) Size 1 Phillips screwdriver a) Locate WZB-05ET within 1.0m of AC mains socket and with at least 15cm (approx.. 6 inches) spacing on each side (except on mounting side) avoiding the following sources of interference: direct sunlight, air flow from vents, fans, doors, windows, heaters, sources of steam, oil vapor,...
Powering on WZB-05ET (See Powering On WZB-05ET) b) If necessary, remove WZB-05ET from the mounting cradle. c) If WZB-05ET will be added to a network, reserve an IP address and port on that network for WZB-05ET – check with local network administrator to obtain configuration details.
Page 5
WZB-05ET User’s Manual that will not cause conflict, (eg. 10010) if WZB-05ET will not be networked → click “Submit” to make the changes as shown below. g) Click on “Miscellaneous Setting” on the left side of the screen. → Update the “IP Address Selection”...
Use a sharp pointed tool to apply 1 quick press to the link switch on WZB-05ET, the blue LED will flash twice every 3 seconds for up to 60 seconds to permit join other devices to its network.
Use pin or other appropriate tool to apply 2 quick presses to link switch on WZB-05ET → the blue light should flash rapidly for up to 30 seconds or until removal has been successful.
Once WZB-05ET has been removed from the network or reset, it is suggested to remove power from the WZB-05ET when not in use to reduce power wastage, RF traffic, and unintentional joining to original or new network.