Sony slt-a35 Instruction Manual page 112

(Auto Exposure
Diff.)
(Exposure
Difference Level)*
* _Ev displayed with
Shooting technique
• Since the shutter is released three times for one shot, be careful about the
following:
– Use this function when the subject is motionless or does not blink.
– Do not recompose.
Notes
• You cannot use this function on RAW images.
• When the exposure mode is set to AUTO, AUTO+, Sweep Panorama, Scene
Selection, or Picture Effect, you cannot select [Auto HDR].
• You cannot select [Auto HDR] during Smile Shutter. If you turn on the Smile
Shutter function with [Auto HDR] selected, the camera will temporarily use with the
DRO setting.
• You cannot start the next shoot until the capture process is completed after you
shoot.
• You may not obtain a desired effect depending on the luminance difference of a
subject and the shooting conditions.
• When the flash is used, this function has little effect.
• When the contrast of the scene is low or when camera shake or subject blur is
occurred, you may not obtain good HDR images. If the camera has detected a
problem,
Shoot again, as necessary, paying attention to the contrast or blur.
112
Corrects the exposure difference automatically.
Sets the exposure difference, based on the contrast of the
subject. Select the optimal level between 1.0Ev (weak) and
6.0Ev (strong).
For example: When 2.0Ev is selected, three images are
overlaid: an image with –1.0Ev, an image with the correct
exposure, and an image with +1.0Ev.
is the step currently selected.
is indicated on the recorded image to inform you of this situation.