Panasonic tc-p42s1 Operating Instructions Manual page 39

Automatically searches and adds a vailable channels tothe memory.
_ Select " ANT in" @Select a scanning m ode (p.18)
,,,,,,_, Select Cable orAntenna (p. 1 7)
Orselect "Not used" toskip TVtuning. C2_'ok
Select "Auto program"
_select
next
i_select
Settings are made automatically
® After the scanning is completed, select "Apply".
(see below @).
® All previously saved channels are erased.
Use this procedure when changing the channel setup or
changing the channel display.
Also, use this to add or skip channels from the channel
list manually.
You can select a channel tuning mode (Digital only/
Analog only) in "Channel surf mode'(p. 29)
_1_Select "Edit"
Select the item to be edited
Caption Add Changes the station identifier
Favorite:
Registers channel to Favorite
List
÷ Add:
R __ Proceed to Adds or skips channels
next page
Go back to previous page
_3_Edit
® Caption
set/next
RHB
UDI[_
or
trJOD
B
Select or edit the station identifier.
(maximum 7 characters available)
® Favorite
Set favoriteJ Select the number
® Add RETURN
Press OK to select "Yes (add)" or "No (skip)" @
@ Move cursor to channel number
®
To cancel the Edit
Check the signal strength if an interference is found or freezing occurs on a digital image.
g B m ® If the signal is weak, check the antenna.
H H m _ If no problem is found, consult your local dealer.
U B B or .u_change
channel
m #_ok
intensity ® Not available if "Cable" is selected in "ANT in"
(see above).
® Available only for digital antenna channels.
® If "Lock" (p. 36) is activated and "ANT/Cable setup" is selected, "Enter password." will be displayed.
@
m
o_
m,
o_
O0
d)
m,
C)
::y
d)
U_
39