Table of Contents
Advertisement
Relocating the main controls
The main controls can be relocated to the bottom surface or right panel of the monitor depending on such factors as where
and how the monitor will be used.
<Note>
Before relocating the main control, make absolutely sure that the power has been turned off.
1
Disconnect the cord connecting the main controls to the
main unit.
2
Remove the screws on the right panel of the main unit.
3
Remove the two screws, and remove the main controls
from the main unit.
removed from the main controls themselves.
8
Take hold of this part
and pull it free to
disconnect the cable.
These two screws cannot be
4
Use the two screws to secure the main controls to the
right panel.
5
Plug the cord connecting the main controls into the
connector on the main unit and secure it.
<Note>
Using too much force to plug in the cord at the wrong
insertion angle may damage the pins inside. Check out
the shape of the connector before plugging it in.
6
Secure the two screws, which were removed in step
in the screw holes on the bottom of the monitor.
Plug in the connector
until it clicks into place.
2
,
Advertisement
Table of Contents
