Page 2
Thank you for purchasing this product. For optimum performance and safety, please read these instructions carefully before connecting, operating or adjusting this product. Please keep this manual for future reference. n Introduction This range of high performance HDMI switch provide four HDMI in to one HDMI output and supports PIP, 4K×2K, 3D, Deep Color.
Page 3
Support display resolutions up to 4K x 2K@30Hz,1080P@120Hz,and 1080P 3D@60Hz Support deep color 30bit, 36bit, 48bit per pixel. Digital audio format, as DTS-HD/Dolby-true-HD/LPCM 7.1/DTS/Dolby-AC3/DSD. n Package HDMI Switch ------------------------------------------------------------------------------ 1PCS 5V1A DC Power Supply adaptor ------------------------------------------------------- 1PCS Remote Controller ------------------------------------------------------------------------ 1PCS Operation Manual ------------------------------------------------------------------------- 1PCS n Specifications Frequency Bandwidth...
Page 4
± 8kV (air-gap discharge) ESD Protection Human Body Model: ± 4kV (contact discharge) Dimensions (mm) 65(W) X 118 (D) X 25 (H) Weight 120g Operating Temperature 0°C ~ 40°C / 32°F ~ 104°F Storage Temperature -20°C ~ 60°C / -4°F ~ 140°F Relative Humidity 20 ~ 90% RH (Non-condensing) Power Consumption...
Page 5
This red LED illuminates when the device is connected with power supply POWER: Press this button to select the input source. SWITCH: IR: Remote control signal receive. OUTPUT LED: this green LED illuminate when TV plug in over HDMI cable. INPUT LED: These bi-color LED describe corresponding status.
Page 6
Rear Panel HDMI INPUT: This slot is where you connect the HDMI source output from DVD, PS3. HDMI OUTPUT: HDMI signal output, connect to TV over a HDMI cable.
Page 7
Left Panel DC 5V: Plug the 5V DC power supply into the unit and connect the adaptor to AC wall outlet.
Page 8
Remote control Select input signal to be showed on the TV. No function in this HDMI 3X1 Switch. PIP operation area: PIP: Open/close the PIP function. SEL: Select a sub-picture to be main picture. Enter: Enter the sub-picture which has been selected to be main picture.
Need help?
Do you have a question about the HDS-931P and is the answer not in the manual?
Questions and answers