Summary of Contents for Taski Intellibot AeroBot 1850
- Page 1 Quick Reference Guide ™ Hands–Free Cleaning Floor Sweeper ® 5410 SW Macadam Ave, Suite 100 Portland, Oregon 97239 www.intellibotrobotics.com...
-
Page 2: Table Of Contents
Quick Reference Guide TABLE OF CONTENTS Page Introduction Customer Assistance Machine Images Operator Control Panel Overview Start Up Steps Clearing Obstacles Manual Clean Hands-Free Spot Clean Hands-Free Area Clean Cleaning Patterns Map Clean (optional) Parking and Charging Exchanging Battery Packs ©... -
Page 3: Introduction
Quick Reference Guide Introduction This quick reference guide contains information on the daily operation and care of the AeroBot Vacuum. Read it carefully and become familiar with its contents. It is important to follow all instructions and any warnings contained within this guide. Ignoring them could result in personal injury or damage to the AeroBot Vacuum that may not be covered by the limited warranty. -
Page 4: Machine Images
Quick Reference Guide Sonars Electronics box Safety touch shield © 2013 Intellibot Robotics, LLC All Rights Reserved v3 Page 4... -
Page 5: Operator Control Panel Overview
Quick Reference Guide Operator Control Panel Overview Amber warning light: Provides a visual indicator that the machine is operating. On/Off button: Press this button to power on the machine. A green ring will light up when pressed. You can use the same button to power down the machine. -
Page 6: Start Up Steps
Quick Reference Guide Start Up Steps 1. Disconnect the Battery Charger (it will not start if connected). 2. Press the “ON” button. Note: It takes almost two (2) minutes for the machine to fully power up. 3. Touch the Log In button. 4. - Page 7 Quick Reference Guide 5. Enter your operator code and Touch “OK”. (If your operator code is unknown, contact your administrator.) Once you enter your operator code, a series of screens will appear that prompt you through the Release parking break. ©...
-
Page 8: Clearing Obstacles
Quick Reference Guide Clear Obstacles Before Cleaning: Make sure the area to be cleaned is as clutter-free as possible by removing all items from the area such as garbage bags, trashcans and cleaning carts. Cleaning Options There are two operating modes for the AeroBot: Manual and Hands Free. Manual allows you to control all cleaning functions including speed and water flow. -
Page 9: Hands-Free Spot Clean
Quick Reference Guide Hands-Free Spot Clean Spot Clean is used to clean a hallway or aisle for a specific distance (minimum of 20 feet). The hallway/aisle must be between 5.5 feet and 60 feet wide. There must be two walls, one on the left and one on the right, at the start of Spot Clean for it to accurately measure the width of the area to clean. -
Page 10: Hands-Free Area Clean
Quick Reference Guide Hands-Free Area Clean Use this mode to clean hallways, conference rooms and aisles 5.5 feet to 60 feet wide automatically. Area Clean can clean an area with only one sidewall as a reference, but works best when both a left and right wall are present. -
Page 11: Cleaning Patterns
Quick Reference Guide Cleaning Patterns: Single Area Single Area Return Side T Right Side T Right Return L Left L Left Return Side T Left Side T Left Return L Right L Right Return Cross Left Cross Left Return T Left T Left Return Cross Right Cross Right Return... - Page 12 Quick Reference Guide 2. Use Left and Right arrows to choose a Hands- Free pattern. Once you select a cleaning pattern, touch “Go.” On the first pass (learning pass) of the first Area, the machine looks for openings that match the Cleaning Pattern selected. Note: If the hallway does not match the pattern you selected, the machine will only clean the first leg.
-
Page 13: Map Clean (Optional)
Quick Reference Guide Map clean (optional) Map clean is created with an optional software package. Maps are created and stored on the machine. Each map has a unique starting location. The machine must be within 2 feet of that starting location and oriented in the proper direction for the route to run successfully. 1. -
Page 14: Parking And Charging
Quick Reference Guide Parking and Charging. 1. Maneuver the machine to the charging station. 2. Power down by pressing the on/off button on the control panel. Exchanging Battery Packs 1. Set the parking brake. WARNING: THE BATTERY PACK CONTAINS 4 BATTERIES, ALL OF WHICH HAVE AN ACTIVE CHARGE THAT CAN CAUSE PERSONAL INJURY.
Need help?
Do you have a question about the AeroBot 1850 and is the answer not in the manual?
Questions and answers