Pioneer DEH-X6900BT Owner's Manual page 16

[FROM TRACK], [FROM ARTISn
PAUSE
EQSETTING
[SUPER BASS], [POWERFUL],
[NATURAL], [VOCAL], [CUSTOM 1 ],
[CUSTOM2], [FLAn
Select an equalizer band and
level for further customizing.
Equalizer band: [50HZ] to
[1 2.5kHZ]
Equalizer level: [-6] to [+6]
FADER*1
(Only for standard mode)
BALANCE
SUBWOOFER
[ON], [OFF]
SUBWOOFER*2
[NOR], [REV]
16
En
Store the track information currently. being
played in your Pandora account.
Create a new station based on the track or artist
currently being played.
Pause or resume playback.
Start playback.
Stop playback.
Select or customize the equalizer curve.
• When you select a setting other than
[CUSTOM1] and [CUSTOM2], you can also
customize the equalizer curve by pressing and
holding the
M.C.
dial, then store the
customized equalizer curve in [CUSTOM1].
Adjust the front and rear speaker balance.
Adjust the left and right speaker balance.
Set to [ON] when using a subwoofer speaker.
Select the subwoofer phase.
SPEAKER LEVEL
Network mode: [HIGH L], [HIGH
R], [MID L], [MID R], [SUBWOOFER]
Standard mode: [FRONT L],
[FRONT R], [REAR L], [REAR R],
[SUBWOOFER]
Output level: [-24] to [1 0]
CROSSOVER
POSITION
[OFF], [FRONT LEFT] (front seat
left), [FRONT RIGHn (front seat
right), [FRONn (front seats), [ALL]*
*Only for standard mode
TIME ALGNMNT
[INITIAL], [OFF], [CUSTOM]
Select a type of speaker and
adjust the speaker distance for
further customizing in [CUSTOM].
Network mode: [HIGH L], [HIGH
R], [MID L], [MID R], [SUBWOOFER]
Standard mode: [FRONT L],
[FRONT R], [REAR L], [REAR R],
[SUBWOOFER]
Speaker distance (inch}: [1 40] to
[0]
SAVE SETTINGS
[YES], [CANCEL]
LOAD SETTINGS
Select a speaker unit (filter) and adjust the
output level.
• Each value you have adjusted changes when
you change the [POSITION] setting (page 1 6).
Select a speaker unit (filter) to adjust the HPF or
LPF cut-off frequency and the slope for each
speaker unit.
For details on the [CROSSOVER] setting, see
page 14.
Select a listening position to adjust the speakers'
output levels automatically and add a delay time
that corresponds to the number and locations of
occupied seats.
Select or customize the time alignment settings
to reflect the distance between the listener's
position and each speaker.
• Select [INITIAL] to initialize the setting value.
• Select [OFF] to reset all setting values to 0.
• The [CUSTOM] setting is available when
[FRONT LEFn or [FRONT RIGHn is selected in
[POSITION] (page 1 6).
• The [CUSTOM] setting is not available when
[OFF] is selected in [SUBWOOFER] (page 1 6).
Save to later recall the following sound settings
at their current values: [CROSSOVER], [SPEAKER
LEVEL], [EQ SETTING], [POSITION], [TIME
ALGNMNn, [BASS BOOST], [SUBWOOFER].
Load the sound settings, when you have already
performed [SAVE SETTINGS].