Download Print this page

Royal 680 Assembly Instruction Manual page 10

Advertisement

10/12
IT
1.9 RIASSEMBLAGGIO
DELL'INSERTO
Riposizionare nella propria sede il
controcassetto avendo cura di fissarlo
mediante le viti precedentemente tolte,
avendo cura di sostitire la guarnizione nel
caso in cui fosse rovinata.
NB: Una cattiva sigillatura sarà causa di
aspirazione di fumi dal ventilatore il quale
li manderà in ambiente con conseguente
odore di fumo in casa.
Rimontare tutte le altre parti avendo cura
di posizionarle correttamente.
Il ventilatore funzionerà solo a caminetto
acceso e si avvierà dopo circa 15-20
minuti dall'accensione.
Fig. 12
1.10 MANCATO FUNZIONAMENTO
DEL VENTILATORE
Accertarsi che ci sia tensione alla
centralina;
che il fusibile non sia bruciato;
che il termostato sia efficiente;
la temperatura di intervento é di 46 °C.
1.11 DISTRIBUZIONE DELL'ARIA
CALDA SU PIÙ LOCALI
Esempio di condutture canalizzate.
Portate ottimali d'aria si ottengono con
condutture di lunghezza massima di 2
metri in per singolo canale e di 6 metri in
canale singolo.
Lunghezze maggiori possono essere
eseguite tenendo presente che riducono
la portata d'aria.
Per una maggiore resa isolare le
condutture con lana di vetro.
Dati elettrici:
Alimentazione elettrica: 230 V, 50 Hz
Fig. 13
cod. 004722623 - 04/2011
GB
1.9 REASSEMBLING THE
INSERTO
Replace the counter box in its housing,
making sure to fasten it by means of the
previously removed screws, and replace
the gasket if it has been damaged.
NB: Bad sealing will cause the fan to take
in smoke which it will release into the
room, leaving a smell of smoke in the
home.
Re-assemble all the parts, positioning
them correctly.
The fan will work only when the fireplace
is lit, and it will start up about 15-20
minutes after lighting.
1.10 FAILURE OF FAN TO WORK
Make sure the control unit is
powered;
that the fuse has not blown;
Check that the thermostat is
working properly; activation
temperature is 46°C.
1.11 DISTRIBUTION OF WARM AIR
TO SEVERAL ROOMS
Example of ducting.
Best air flow rates are obtained with ducts
with a maximum length of 2 metres for
dual ducts and 6 metres for a single duct.
Greater lengths can be used, but they will
reduce the air flow rate.
For greater performance, insulate the
ducts with fibreglass wool.
Electrical data:
Electrical power supply: 230 V, 50 Hz
KIT VENTILAZIONE

Advertisement

loading

Related Products for Royal 680