D-Link DWL-G630 Quick Installation Manual page 8

Appendix B - Using the Air Plus
(continued)
• SSID: The Service Set Identifier is the name assigned to the wireless network. The
factory SSID setting is set to default. Make changes here to match the SSID on
existing Wireless Router or Access Point.
• Wireless Mode: The factory setting is set to Infrastructure. Ad-Hoc mode is used
for peer-to-peer networking.
• Channel: By default, the channel is set to 6. Channel selection is automatically
adjusted by the DWL-G630 depending on the channel setting of the access point
selected for association. To change the channel settings, the Wireless Mode must
be set to Ad-hoc.
• TxRate: You can adjust the transmission rate to get the best signal possible
depending on your usage and your environment.
• Preamble: The default setting is set to "Short & Long Preamble". The preamble
setting must match the preamble setting of the wireless router or access point in
order to connect.
• Power Mode: By default, Power Mode is set to Continuous Access Mode.
Continuous Access Mode: This default setting consumes the most power.
Maximum Power Save: This setting consumes the least power.
Power Save: This setting consumes a moderate amount of power.
™
G Utility
8