Table of Contents
Advertisement
Configure Sony edge recording and video trickling
Video trickling is supported on Sony units with firmware 1.61 and later in Omnicast through the
Sony Edge Storage (edge recording) feature. To use edge recording and video trickling on Sony
cameras, you must enable the Edge Storage, and configure some additional settings on the unit's
Web page.
1
Open the unit's Web page.
2
Click
Setup > Edge
3
In the
Edge Storage
NOTE
change the video stream type.
4
Click the
In the
5
Image memory
6
Click the
7
In the
Alarm recording
8
Click the
9
In the
Periodical recording
genetec.com | Omnicast Video Unit Configuration Guide 4.8 SR3
EN.100.007-V4.8.C3.(1)
Storage.
option, click On, and then click OK.
If you set the
Effective period
Image memory
tab, and then click the
option, click Off, and then click
Alarm recording
tab.
option, click Off, and then click OK.
Periodical recording
option, click
option to Always, edge recording is stopped if you
Common
tab.
Off,
and then click OK.
tab.
OK.
Sony
84
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the omnicast 4.8 SR3 and is the answer not in the manual?