Page 8
32LH570B-CC 43LH5700-CD 217.9 81.5 製造商 / Manufacturer : APD 型號 / Model : DA-48G19 AC/DC適配器 / 製造商 / Manufacturer : Lien Chang 32LH570B-CC AC/DC Adapter 型號 / Model : LCAP45 輸入 / Input : AC 100-240 V~ 50/60 Hz 產量 / Output : 19 V 2.53 A 43LH5700-CD...
Page 9
OWNER’S MANUAL Safety and Reference LED TV* * LG LED TVs are LCD TVs with LED backlighting. Please read this manual carefully before operating your TV and retain it for future reference. www.lg.com...
Safety instructions Please read these safety precautions carefully before using the product. Insert power cable plug completely into wall socket otherwise if not WARNING secured completely into socket, fire ignition may break out. Clean only with dry cloth. Do not place the TV and/or remote control Ensure the power cord does not come into contact with hot objects in the following environments: such as a heater.
Page 11
Keep the anti-moisture packing material or vinyl packing out of the Do not spray water on the product or scrub with an inflammable reach of children. Anti-moisture material is harmful if swallowed. If substance (thinner or benzene). Fire or electric shock accident can swallowed by mistake, force the patient to vomit and visit the nearest occur.
Page 12
Only use an authorized AC adapter and power cord approved by LG Electronics. Otherwise, this may result in fire, electric shock, If you install the TV on a stand, you need to take actions to prevent malfunction or product deformation.
Page 13
Only use the specified type of battery. This could cause damage to the Please follow the installation instructions below to prevent the remote control. product from overheating. • The distance between the product and the wall should be more than 10 cm. •...
Page 14
Avoid touching the screen or holding your finger(s) against it for long Refer all servicing to qualified service personnel. Servicing is required periods of time. Doing so may produce some temporary or permanent when the apparatus has been damaged in any way, such as power distortion/damage to screen.
Page 15
- High-Speed HDMI ®/ cable with Ethernet Refer to “ON” (power). • When you use the VOD (Video On Demand) service for LG Smart TV, some smart functions may not be supported including web Refers to dangerous voltage. browser. (Only LH57**) CAUTION •...
TV originally came in. NOTE • Before moving or lifting the TV, disconnect the power cord and • LH57 series does not have a Joystick button but has only a power all cables. On/Off button. • When holding the TV, the screen should face away from you to avoid damage.
LG recommends that wall mounting be performed by a qualified professional installer. We recommend the use of LG’s wall mount bracket. The LG wall mount is easy to adjust or 10 cm to connect the cables. When you do not use LG’s wall mount bracket,...
NOTE CAUTION • The external device connection may differ from the model. • Remove the stand before installing the TV on a wall mount by • Connect external devices to the TV regardless of the order of the performing the stand attachment in reverse. TV port.
Remote control (MUTE) Mutes all sounds. Scrolls through the saved programmes. Moves to the previous or next screen. The descriptions in this manual are based on the buttons on the remote control. Please read this manual carefully and use the TV correctly.
Page 20
(Depending on model) Accesses the quick menu. (Q. Settings) Accesses the quick settings. Navigation buttons (up/down/left/right) Scrolls (POWER) Turns the TV on or off. through menus or options. Selects Radio, TV and DTV programme. Selects menus or options and confirms your input. Recalls your preferred subtitle in digital mode.
5725 to 5850 MHz disclaimers and copyright notices are available for download. 802.11a: 16.5 dBm LG Electronics will also provide open source code to you on CD-ROM Output 802.11b: 16 dBm for a charge covering the cost of performing such distribution (such power 802.11g: 15.5 dBm...
Page 24
Record the model number and serial number of the TV. Refer to the label on the back cover and quote this information to your dealer when requiring any service. MODEL SERIAL...
OWNER’S MANUAL EXTERNAL CONTROL DEVICE SETUP Please read this manual carefully before operating the set and retain it for future reference. www.lg.com...
(TV) (PC) • LGTV supports PL2303 chip-based (Vendor ID : 0x0557, Product ID : 0x2008) USB to serial converter RS-232C IN which is not made nor provided by LG. (CONTROL & SERVICE) (PC) (TV) • It can be purchased from computer stores that carry accessories for IT support professionals.
EXTERNAL CONTROL DEVICE SETUP (TV) (PC) (TV) (PC) Phone jack Type RS-232C IN • You need to purchase the phone-jack to RS-232 cable required for the connection between the PC and (CONTROL & SERVICE) (PC) (TV) the TV, which is specified in the manual. RS-232C IN (CONTROL &...
EXTERNAL CONTROL DEVICE SETUP Communication Parameters • Baud rate : 9600 bps (UART) • Stop bit : 1 bit • Data length : 8 bits • Communication code : ASCII code • Parity : None • Use a crossed (reverse) cable. Command reference list (Depending on model) DATA...
EXTERNAL CONTROL DEVICE SETUP Transmission / Receiving Protocol Transmission [Command1][Command2][ ][Set ID][ ][Data][Cr] [Command 1] : First command to control the TV. (j, k, m or x) [Command 2] : Second command to control the TV. [Set ID] : You can adjust the [Set ID] to choose desired monitor ID number in option menu. Adjustment range in TV is 1 to 99.
Page 31
EXTERNAL CONTROL DEVICE SETUP * Commands may work differently depending on model and signal. 01. Power (Command: k a) Ack [d][ ][Set ID][ ][OK/NG][Data][x] ► To control Power *On or Off of the set. * In case of video mute on only, TV will display On Transmission[k][a][ ][Set ID][ ][Data][Cr] Screen Display(OSD).
Page 32
EXTERNAL CONTROL DEVICE SETUP Data Min : 00 to Max : 64 Data Min : 00 to Max : 64 Ack [i][ ][Set ID][ ][OK/NG][Data][x] Ack [r][ ][Set ID][ ][OK/NG][Data][x] 09. Tint (Command: k j) * (Depending on model) ► To adjust the screen tint. 14.
Page 33
EXTERNAL CONTROL DEVICE SETUP Data 02 : Input Source (Digital) Step Frequency - 10 : Antenna TV (DTV) 0(decimal) - 20 : Antenna Radio (Radio) 1st Band - 40 : Satellite TV (SDTV) 1(decimal) 2nd Band - 50 : Satellite Radio (S-Radio) 3rd Band - 90 : Cable TV (CADTV) - a0 : Cable Radio (CA-Radio)
Page 34
EXTERNAL CONTROL DEVICE SETUP * Digital Antenna/Cable * Digital Antenna/Satellite Data 00: xx (Don't care) Data 00 : xx (Don't care) [Data 01][Data 02]: Major Channel Number [Data 01][Data 02]: Major Channel Number Data 01: High byte Channel Data Data 01 : High byte Channel Data Data 02: Low byte Channel Data Data 02 : Low byte Channel Data - 00 01 ~ 27 0F (Decimal: 1 ~ 9999)
Page 35
11 11 EXTERNAL CONTROL DEVICE SETUP 22. Key (Command: m c) 25. 3D(Command: x t) (only 3D models) (Depending on model) ► To send IR remote key code. ► To change 3D mode for TV. Transmission [m][c][ ][Set ID][ ][Data][Cr] Transmission [x][t][ ][Set ID][ ][Data 00][ ][Data 01] Data Key code - p.2.
Page 36
EXTERNAL CONTROL DEVICE SETUP 26. Extended 3D(Command: x v) (only 3D models) 27. Auto Configure (Command: j u) (Depending on model) (Depending on model) ► To change 3D option for TV. ► To adjust picture position and minimize image shaking automatically. It works only in RGB (PC) Transmission [x][v][ ][Set ID][ ][Data 00][ ] mode.