Maintenance And Service; Maintenance And Cleaning - Bosch LR 1 User Manual

OBJ_BUCH-780-003.book Page 28 Tuesday, January 19, 2010 10:56 AM
28 | English
Attaching with the Holder (see figure A)
With the holder 17, the measuring tool can be fastened to a con-
struction laser measuring rod 15 (accessory) as well as to other
auxiliary tools with a width of up to 65 mm.
Screw the holder 17 to the retainer opening 12 on the rear side of
the measuring tool with fastening screw 16.
Loosen the locking screw 13, slide the holder onto the construc-
tion laser measuring rod 15, for example, and retighten the locking
screw 13.
The upper edge 14 of the holder is located at the same height as
the centre mark 5 and can be used for marking of the laser beam.
Attaching with the Magnet (see figure B)
When a positive-lock attachment is not absolutely required, the
measuring tool can be attached to steel parts via the face side us-
ing the magnet plate 4.

Maintenance and Service

Maintenance and Cleaning

Keep the measuring tool clean at all times.
Do not immerse the measuring tool in water or other fluids.
Wipe off debris using a moist and soft cloth. Do not use any clean-
ing agents or solvents.
If the measuring tool should fail despite the care taken in manufac-
turing and testing procedures, repair should be carried out by an
authorised after-sales service centre for Bosch power tools. Do not
open the measuring tool yourself.
In all correspondence and spare parts orders, please always in-
clude the 10-digit article number given on the type plate of the
measuring tool.
2 610 A12 917 | (19.1.10) Bosch Power Tools