Page 1
Part # W498 INSTALLATION AND OPERATING MANUAL MODEL GF-120 for flush mounting inside a wall only MODEL GH-120 for surface mounting against a wall only Important: Instructions must stay with unit. Owner read carefully. WARNING: This manual must be read and understood before installation, adjustment, service or maintenance is performed.
IMPORTANT SAFETY INSTRUCTIONS Polarization Instructions for models H120 and CM120 (with cord) only. These appliances have a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet.
Page 4
Fig.: A WAND HOLDER Installation: for wood surface use the 2 screws supplied with the wand holder package. for dry-walls use two 1-1/2 long screws from the fastener package. NOTE: the wand holder should be mounted against a wall stud for extra strength. Fig.: B...
HOW TO OPERATE YOUR VACUUM CLEANER MODELS: GF-120 + GH-120 NOTE: THE LOWER PART OF THE VACUUM CLEANER WILL BE QUITE WARM WHEN IN USE. IF THE VACUUM STOPS RUNNING: ABOUT 1-1/2 HOUR. THE THERMAL PROTECTOR ON THE MOTOR WILL RESET AUTOMATICALLY AFTER PLEASE SEE TROUBLE SHOOTING GUIDE.
Page 7
Fig.: E D: Replacing Exhaust Filter, Part #Y41: Pinch exhaust filter in the middle and pull out. E. Replacing motor filter To replace, pinch in the middle and slide in Part # Y21 one side first. ( washable by hand) tuck-in the corners and sides carefully under the ribs TROUBLE SHOOTING:...
Page 8
ACCESSORIES Wand Holder Part # X153 Floor Tool with rollers and horse hair PART# A002 2 Part Upholstery Tool with horse hair 40’ Stretch Hose PART # X300 Assembly PART# A002 Elongated Brush for Car Dash Board PART# A002 Crevice Tool PART # X200 REPACEMENT DUST BAGS: PART # Y08-5 (5 pack) HEPA Type 5 layer fiber filtration...