AEG AWH9410 User Manual page 5

display
Speed 2: the number "2" appears on the
display
Speed 3: the number "3" appears on the
display
High-speed: the number "4" appears
(fl ashing) on the display
The high-speed function is regulated by
a timer. The standard time setting is 5',
at the end of which the hood adjusts to
speed 2.
Press button 2 to deactivate this function
before the set time expires; the hood will
adjust to speed 1. Press button 1 to turn
the hood off.
3. Lights ON/OFF button
4. Speed timer button
5. Display
Speed timer button
Press button "4" to activate the speed timer;
the hood turns off once the set time expires.
The timer functions in the following way:
• Speed 1 - 20 minutes (the number "1"
and a small fl ashing LED light appear on
the display)
• Speed 2 - 15 minutes (the number "2"
and a small fl ashing LED light appear on
the display)
• Speed 3 - 10 minutes (the number "3"
and a small fl ashing LED light appear on
the display)
• High-speed - 5 minutes (the number "4"
and a small fl ashing LED light appear on
the display)
Press button 1 or button 4 to turn the hood
off while the speed timer is in function; by
pressing button 2, the hood returns to the
set speed.
Saturation indicator of the grease fi lter
After 80 hours of operation, the display
shows alternately the set speed and the
letter "F".
Saturation indicator of the charcoal fi lter
After 320 hours of operation, the display
shows alternately the set speed and the
letter "C".
Reset of saturation indicator
In order to reset the saturation indicator,
switch on the hood then press and hold
button 1 for about 3 seconds.
Perform fi lter maintenance as
recommended in this manual.
In the event that both indicators of fi lter
saturation "F" and "C" start fl ashing,
proceed with the reset twice.
The saturation indicator of the charcoal
fi lter is not normally active and if the hood
is used in the recirculation mode, it must be
activated manually the fi rst time.
Activation of the charcoal fi lter
saturation indicator:
Turn off the hood and simultaneously press
buttons 2 and 3 for 3 seconds.
The letters "F" and "C" will fl ash on the
display for 2 seconds, to indicate successful
activation of the saturation indicator of the
charcoal fi lter.
Deactivation of the charcoal fi lter
saturation indicator:
Turn off the hood and simultaneously press
the buttons 2 and 3 for 3 seconds. Only
letter "F" will fl ash on the display for 2
seconds, to indicate successful deactivation
of the saturation indicator of the charcoal
fi lter.
LIGHTING
Disconnect the hood from the electricity.
Warning! Prior to touching the light bulbs
ensure they are cooled down.
Replace with a new 12 Volt, 20 Watt
(Maximum) halogen light made for a G-4
base SUITABLE FOR USE IN OPEN
LUMINAIRES. Follow package directions
and do not touch new light with bare hands.
ENGLISH 5