Install The Hardware - Axis T8127 Installation Manual

Install the Hardware

See System Overview on page 9 for a system overview image.
See Hardware Overview on page 8 for positions of connectors and
switches.
This product is intended for indoor use only.
Mount the PoE splitter as close as possible to the powered device.
Before installation, make sure that the voltage switch is in correct position
for the powered device. Default is 12 V DC. For devices that require
24 V DC, set the voltage switch selector to 24 V DC.
NO TICE TICE
NO NO TICE
Using the wrong power level might cause damage to property.
1. Connect an Ethernet cable from the splitter's DATA OUT port
to Ethernet input on the powered device.
2. Connect the supplied power cord cable from the splitter's
DC OUT port to power input on the powered device.
3. Connect an Ethernet cable from the PoE device to the splitter's
POWER & DATA IN port.
4. Place a cover sticker on the voltage switch selector.
5. Verify that the splitter's PWR OUT LED is lit.
6. Verify that the powered device powers up.
AXIS T8127 60 W Splitter 12/24 V DC
7