Advertisement
Step 1: Turn on the controller, while both switches on top of the controller are turned down, and plug the battery into the copter.
While the copter is on a horizontal surface.
Step 2: (in mode 2) hold the left joystick in the lower position and switch the heading lock switch (top left) a couple of times until
the indication light on the back of the copter turns green.
Step 3: Now spin the copter in circles in a horizontal position without the green indicator turning off for 3 rounds.
Step 4: Repeat step 2, but this time the light should be turned completely off.
Step 5: The indication light of the copter should now turn red when the copter is hold in a vertical position.
Step 6: Spin the copter in 3 circles while holding it in a vertical position, without the red light turning off.
Step 7: Put down the copter on a horizontal surface.
Step 8: Hold the left joystick in the lower position and switch the heading lock switch (top left) a couple of times just like you did at
step 2 and 4. Now the indication light should be turned full green.
Step 9: Wait about 30 to 120 seconds until the indication light flashes red/green or only green. If not, please repeat from step 1.
Troubleshooting
Copyright WLtoys.eu | DroneX BV
FORWARD
Pushing the directional lever up and down makes your
drone go forward or backward.
ALTITUDE
Pushing the gear lever up and down makes your altitude
rise or fall.
TURN
Pushing the gear lever from side to side, the drone will turn
on its own axis.
Advertisement
