Proper Installation; Save These Instructions - GE G188 Owner's Manual

PROPER INSTALLATION

This washer must be properly installed and located in accordance with the Installation Instructions before it is used.
If you did not receive an Installation Instructions, you can receive one by visiting GEAppliances.ca or by calling
800.561.3344.
Ensure that the hot water hose is connected to the "H"
(internal red screened) valve and the cold water hose is
connected to the "C" (internal blue screened) valve.
Install or store where it will not be exposed to
temperatures below freezing or exposed to the weather,
which could cause permanent damage and invalidate the
warranty.
Properly ground washer to conform with all governing
codes and ordinances. Follow details in the Installation
Instructions.
To ensure proper installation, run two small load size
Whites cycles BEFORE washing the first load.
WHEN NOT IN USE
Turn off water faucets to minimize leakage if a break or
rupture should occur. Check the condition of the fill hoses;
GE recommends changing the hoses every 5 years.
This washer does not include water supply hoses.
GE strongly recommends the use of factory specified
parts. A list of factory hoses available for purchase are
listed below. These hoses are manufactured and tested to
meet GE specifications.
GE strongly recommends the use of new water supply
hoses. Hoses degrade over time and need to be replaced
every 5 years to reduce the risk of hose failures and water
damage.
Parts and Accessories
Call 1.800.661.1616 during normal business hours or contact
your local authorized GE parts distributor.
Part Number Accessory
PM14X10002 4 ft Rubber Water Supply Hoses
Or
PM14X10005 4 ft Braided Metal Water Supply Hoses

SAVE THESE INSTRUCTIONS

GEAppliances.ca
3