Table of Contents
Advertisement
5 Connecting to power supply
Switch-on phase
26
5.6
Switch-on phase
After VEGASON 62 is connected to voltage supply or after voltage
recurrence, the instrument carries out a self-check for approx. 30
seconds. The following steps are carried out:
•
Internal check of the electronics
•
Indication of the instrument type, the firmware as well as the sen-
sor TAGs (sensor designation)
•
Status byte goes briefly to fault value
Then the current measured value will be displayed and the corre-
sponding digital output signal will be outputted to the cable.
The values correspond to the actual measured level as well as to the settings
1)
already carried out, e.g. default setting.
1)
VEGASON 62 • Profibus PA
Advertisement
Table of Contents
