Congratulations on choosing to buy a TAURUS TITANIUM® product. All products brought to you by TAURUS TITANIUM® are manufactured to the highest standards of performance and safety, and, as part of our philosophy of customer service and satisfaction, are backed by our comprehensive Year Warranty.
1. GENERAL SAFETY RULES plugging in power tools that have the switch on invites accidents. d. Remove any adjusting key or wrench before WARNING! Read all instructions. Failure to turning the power tool on. A wrench or a key left follow all instructions listed below may result attached to rotating part of the power tool may in electric shock, fire and/or serious injury.
2. BATTERY SAFETY RULES 7. Do not exhaustively discharge batteries. Exhaustive discharge will damage the battery cells. The most common cause of exhaustive discharge is lengthy Battery tool use and care storage or non-use of partly discharged batteries. Stop a) Recharge only with the charger specified by the working as soon as the performance of the battery falls manufacturer.
Page 5
8. Never use or charge batteries if you suspect that the When handling batteries beware of electrostatic last time they were charged was more than 12 months charge: Electrostatic discharges cause damage of the previously. There is a high probability that the battery electronic protection system and the battery cells.
3.2 LAYOUT (FIG. 1+3) For use in dry rooms only Safety Class II 11. 1 hour charger 4. Battery pack Output connector of the charging unit (direct current): The outer part of the connector is the 9. ON/OFF button for Battery capacity indicator negative pole and the inner part is the positive pole.
3.5 CLEANING AND MAINTENANCE Always pull out the power plug before starting any cleaning work. The equipment is not allowed to be stored in a damp location or where there are caustic gases. Keep it in a dry place out of the reach of children.
Caution - Read the operating instructions to • Inspect the equipment and accessories for transport reduce the risk of injury damage. • If possible, please keep the packaging until the end of the Wear ear-muffs. warranty period. The impact of noise can cause damage to hearing.
Wear ear-muffs. Mounting: Push the battery pack (4) onto the equipment until it latches The impact of noise can cause damage to hearing. in place. Total vibration values (vector sum of three directions) determined in accordance with EN 60745. Removing: Impact tightening of fasteners of the maximum capacity Press the pushlock button (5) and pull the battery pack (4) out of the tool...
4.7.5 Loosening screws For as long as the screw is tightened, the tool works as a impact driver. As soon as the screw is loosened, the tool operates as a normal screwdriver. 4.8 CLEANING, MAINTENANCE AND ORDERING OF SPARE PARTS Always pull out the mains power plug before starting any cleaning work.
Page 14
After Sales Support TEL: 1300 922 271 EMAIL: service.australia@einhell.com...
Page 15
After Sales Support TEL: 1300 922 271 EMAIL: service.australia@einhell.com...
Page 16
02/2014 Art.Nr: 42.571.74_11013 After Sales Support TEL: 1300 922 271 EMAIL: service.australia@einhell.com...
Need help?
Do you have a question about the TT-CW 18 Li and is the answer not in the manual?
Questions and answers