How To Use - Panasonic CU-2RE18PBE Operating Instructions Manual

How to use

MODE
To select operation mode
AUTO mode - For your convenience
• During operation mode selection the power
indicator blinks.
• Unit selects operation mode every 3 hours
according to setting temperature, outdoor
temperature and room temperature.
HEAT mode - To enjoy warm air
• Unit takes a while to warm up. The power
indicator blinks during this operation.
COOL mode - To enjoy cool air
• To reduce power consumption during COOL
mode, use curtains to screen off sunlight and
outdoor heat.
DRY mode - To dehumidify the environment
• Unit operates at low fan speed to give a gentle
cooling operation.
To adjust horizontal airfl ow direction
• Manually adjustable.
6
F568939_YS0912-0.indb 6 F568939_YS0912-0.indb 6
Remote control display
AUTO
FAN
SPEED
HEAT
AIR
COOL
SWING
DRY
OFF/ON OFF/ON
MODE FAN SPEED
TEMP TEMP
AIR SWING
TIMER TIMER
ON ON SET SET
1 1 2 2 3 3
OFF OFF CANCEL CANCEL
AC RC
SET CHECK CLOCK CHECK CLOCK RESET
Auto OFF/ON button
Use when remote control is
misplaced or a malfunction
occurs. Raise the front panel:
• To use in AUTO mode, press
the button once.
• To use in COOL mode, press
and hold the button until 1 beep
is heard, then release.
• To use in HEAT mode, press
and hold the button until 1 beep
is heard, then release. And
press again until 2 beeps, then
release.
• Press the button again to turn
off.
Remote control receiver
and indicator
(Green)
POWER
(Orange)
TIMER
Press and hold for
approximately
10 seconds to show
temperature setting in
°C or °F.
Press to restore the
remote control to
default setting.
Not used in normal
operations.
11/23/2012 3:51:48 PM 11/23/2012 3:51:48 PM