Connecting The Telephone Line Cord - Panasonic KX-TG9542 Quick Manual

TG954x_(en)_QG.fm Page 2 Thursday, June 27, 2013 4:13 PM

Connecting the telephone line cord

N To connect to 2 single-line telephone jacks
1
For Line 1: Connect the "Transparent" plug telephone
line cord (2-wire cord) (1) to the unit, then to the Line
1 single-line telephone jack (RJ11C) (2) until you hear
a click.
2
For Line 2: Connect the "GREEN" plug telephone line
cord (4-wire cord) (3) to the unit, then to the Line 2
single-line telephone jack (RJ11C) (4) until you hear
a click.
If you subscribe to a DSL/ADSL service, attach a DSL/ADSL filter to the telephone line between the base
unit and the telephone line jack. Refer to the operating instructions for connections.
Battery installation/Battery charging
Charge for about 7 hours.
Note:
L USE ONLY Ni-MH batteries AAA (R03) size (1).
L Do NOT use Alkaline/Manganese/Ni-Cd batteries.
L Confirm correct polarities (S, T).
L Follow the directions on the display to set up the unit.
L Confirm "Charging" is displayed (2).
Using the unit as a single-line telephone only
1
Connect the "Transparent" plug telephone line cord (2-wire
cord) to LINE 1/2.
Handset/Base unit:
L To use line 1 only: {MENU}(25) s {r}: "Line1" s
{SAVE} s {OFF}/{EXIT}
L To erase the message "Check tel line2":
{MENU}(19)
"Transparent" plug
2
"GREEN" plug
4
2
1
– 2 –
1 2
1 3
1