Protections; Fuse For Circuit Protection - Sanyo PLC-XF40 Service Manual

Protections

The fuse is located in the rear inside a projector. (Refer to figure.) When
either the LAMP indicator or the READY indicator is not illuminated,
fuse may be opened. Check the fuse as following steps.
1. Remove the Cabinet-top following to "Mechanical Disassemblies".
2. Remove the fuse from fuse holder.
3. Check the resistance of fuse using a tester.
To install the fuse, take reversed step in the above.
It should be used the specified fuse as follows;
Fuse Part No.: 423 028 4209
TYPE 15.0A400V FUSE
SOC CORP. SHV14 15A N4
■ The Lamp circuit (the lamp and the electrode of the lamp socket) of this
projector is not insulated from AC line, and it is "HOT." Therefore,
when replacing lamp assembly, an electric shock may be received.
However, the interlock switch (SW902) is designed so that it may protect
from the accident.
■ This switch(SW902) insulates a lamp circuit from AC line, when cover-
top is opened. (The lamp circuit changes to "COLD.")
Fuse
Main sw
AC INPUT
F901
SW901
Downloaded from www.Manualslib.com
❏
Fuse
❏ Protection equipment for users
P.F.C.
Ass'y
Power
P.F.C.
Interlock SW
SW902
manuals search engine
This projector is equipped with the following protec-
tions to operate in safety.
for circuit protection
MJ6A
Lamp 1
Lamp
ballast
Lamp 2
Lamp 3
Lamp
ballast
Lamp 4
Interlock
switch
-4-
Electric shock protection. (Interlock switch)
MJ6A
Lamp socket