Operation; Vacuuming Dry Materials - RIDGID WD19560 Owner's Manual

SP6731-2 16 Gallon E S-v8_SP6567 16 Gallon Steel.qxd 11/21/12 3:14 PM Page 10

Operation

WARNING: To reduce the risk of fire, explosion, or damage to Vac:
• Do not leave Vac running while unattended - you may fail to notice important signs
indicating abnormal operation such as loss of suction, debris/liquid exiting the
exhaust, or abnormal motor noises. Immediately stop using Vac if you notice these
signs.
• Do not leave Vac plugged in when not in use.
• Do not continue running when float has cut off suction.
• Sparks inside the motor can ignite airborne flammables. Do not operate Vac near
flammable liquids or in areas with flammable gases, vapors, or explosive/airborne
dust. Flammable liquids, gases, and vapors include: lighter fluid, solvent-type
cleaners, oil-based paints, gasoline, alcohol, and aerosol sprays. Explosive dusts
include: coal, magnesium, aluminum, grain, and gun powder.
• Do not vacuum up explosive dusts, flammable liquids, or hot ashes.
WARNING: To reduce the risk of electric shock or injury:
• Do not expose to rain or allow liquid to enter motor compartment. Store indoors.
• Do not handle plug, switch, or Vac with wet hands.
• Unplug Vac before servicing. If your Vac is not working as it should, has missing
parts, has been dropped, damaged, left outdoors, or dropped into water, return it to an
independent service center or call customer service.
• When using an extension cord, use only outdoor-rated cords that are in good
condition. Do not allow the connection to come into contact with liquid.
To reduce the risk of electric shock, this
appliance has a polarized plug (one blade
is wider than the other). This plug will fit
in a polarized outlet only one way. If the
plug does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact a
qualified electrician to install the proper
outlet. Do not change the plug in any way.
After you plug the power cord into the
outlet, turn the unit on by pushing the
switch from position "O" to position "l".
The symbols used on the switch actuator
are international "On & Off" symbols.
= OFF
Familiarize yourself with the accessories
included with the Vac. Each accessory may
be used in various ways for vacuuming and
blowing debris. Here is a list of the
accessories and their uses.
Utility Nozzle - General purpose nozzle for
most vacuuming applications.
Wet Nozzle - Used for wet pickup on
smooth surfaces to pick up liquid and dry
the surface in one stroke.
Car Nozzle - Dry pickup nozzle for car
interiors and most upholstery cleaning.
Extension Wands - These wands can be
connected together and provides
additional length for more reach.
Dual-Flex™ Locking Hose - Provides
transfer of vacuum or blowing capability to
work site. Provides the means of attaching
extension wands and nozzles.
Crevice Tool - Use to pick up debris in
hard to reach locations.

Vacuuming Dry Materials

1. The filter must always be in correct
position to reduce the risk of leaks and
= ON
possible damage to Vac.
2. Your Wet/Dry Vac comes with the
VF5000 Filter installed. When using
your Vac to pick up very fine dust, it will
be necessary for you to empty the
drum and clean the filter at more
frequent intervals to maintain peak Vac
performance.
10