Loose Fuel Filler Cap Message; Vehicle Loading - Dodge 2012 Challenger SRT8 Owner's Manual

Hide thumbs Also See for 2012 Challenger SRT8:
Table of Contents

Advertisement

WARNING!
• Never have any smoking materials lit in or near
the vehicle when the gas cap is removed or the
tank is being filled.
• Never add fuel to the vehicle when the engine is
running.
• A fire may result if gasoline is pumped into a
portable container that is inside of a vehicle. You
could be burned. Always place gas containers on
the ground while filling.
NOTE:
• Tighten the gas cap until you hear a "clicking" sound.
This is an indication that the gas cap is tightened
properly. The MIL in the instrument cluster may turn
on if the gas cap is not secured properly. Make sure
that the gas cap is tightened each time the vehicle is
refueled.
• When the fuel nozzle "clicks" or shuts off, the fuel
tank is full.

Loose Fuel Filler Cap Message

If the vehicle diagnostic system determines that the fuel
filler cap is loose, improperly installed, or damaged, a
"Check Gascap" message will display in the Electronic
Vehicle Information Center (EVIC). If this occurs, tighten
the fuel filler cap properly and press the TRIP ODOMETER
button to turn off the message. If the problem continues,
the message will appear the next time the vehicle is started.
A loose, improperly installed, or damaged fuel filler cap
may also turn on the MIL. Refer to "Onboard Diagnostic
System" in "Maintaining Your Vehicle" for further
information.

VEHICLE LOADING

The load carrying capacity of your vehicle is shown on the
"Vehicle Certification Label." This information should be
used for passenger and luggage loading as indicated.
STARTING AND OPERATING 335
5

Advertisement

Table of Contents
loading

Table of Contents