Nailer Operation - Hitachi NR 90AF (S1) Instruction And Safety Manual

English
● Use nail strip of more than 6 nails.
The Nailer is now ready to operate.
Removing the nails:
1 Pull the nail feeder (B) backward.
2 Return the nail feeder (B) forward quietly while
pushing the nail feeder (A).
3 Push the nail stopper toward the magazine side, and
pull out nails from the back of the magazine.
Nails

NAILER OPERATION

Read section titled "SAFETY"(pages 4 – 7).
● Operators and others in work
area
glasses with side shields
which conforms to ANSI Z87.1
specifi cations.
14
6
1
Nail Feeder (A)
2
Nail Feeder (B)
Nail Stopper
3
DANGER
MUST wear safety
● NEVER point tool at yourself or
others in work area.
● Keep
trigger when not driving nails
to avoid accidental fi ring.
● Choice of triggering method is important.
Please read and understand "Methods of
Operation" below.
● Before starting work, check the nailing operation
switching device.
This Hitachi nailer includes a nailing operation
switching device.
Before starting work, make sure that the
switching device is properly set.
If the switching device is not set properly, the
nailer will not operate correctly.
● Never place your hands or feet closer than 8
inches (200 mm) from fi ring head when using.
● Do not drive nails on the top of other nails or
with Nailer at too steep of an angle; nails can
ricochet and hurt someone.
● Do not drive nails into thin boards or near
corners and edges of workpiece. Nails can be
driven through or away from workpiece and hit
someone.
● Never drive nails from both sides of a wall at the
same time. Nails can be driven into and through
the wall and hit a person on the opposite side.
● Never use Nailer which is defective or operating
abnormally.
● Do not use Nailer as hammer.
● Disconnect air hose from Nailer when:
1) it is not in use;
2) leaving work area;
3) moving it to another location;
4) handing it to another person; and
5) changing switching device.
This Hitachi nailer is equipped with a nailer operation
switching device.
Use SINGLE SEQUENTIAL ACTUATION MECHANISM or
CONTACT ACTUATION MECHANISM in accordance with
the work to be performed.
Explanation of the various nailing operations
○ SINGLE SEQUENTIAL ACTUATION MECHANISM:
First, press the push lever against the workpiece;
next, pull the trigger to drive the nail.
After nailing once, nailing will not be possible again
until the trigger is released and pressed again.
WARNING
fi ngers AWAY from