Advertisement
Available languages
Available languages
Components
TY-WK5P1RW
Parts used to assemble the wall-hanging bracket
Base upper fitting
Base lower fitting
Label
Parts used for installation
View of fully assembled fixtur
Precautions for wall-hanging bracket fitting
♦ The wall-hanging bracket is for use in attaching a plasma TV unit to a vertical wall for viewing. Do not fit to
any surface other than a vertical wall.
♦ To ensure correct plasma TV performance and prevent trouble, do not fit at any of the following locations.
• Near sprinklers or fire/smoke detectors
• Where there is a risk of exposure to vibration or impact
• Near high-voltage wires or dynamic power supplies
• Near sources of magnetism, heat, water vapor or soot
• Locations exposed to air blown from heating equipment
• Where droplets of condensation from an air conditioner or other unit may form
♦ Fit using techniques suited to the structure and materials of the fitting location.
♦ Use commercially available screws with a nominal diameter of 6 mm (0.2 inches) that are suited to the wall
material (wood, steel frame, concrete etc.) you are fitting the bracket to.
♦ For the TV power supply plug, use a power supply outlet that can be reached easily.
♦ Ensure good air flow so that the equipment ambient temperature does not exceed 40 °C (104 °F). Failure to
do this may cause heat to build up inside the plasma TV, resulting in malfunction.
♦ Spread a soft blanket or cloth over the floor so that the plasma TV and floor will not be marked or scratched
during the assembly and installation work.
♦ When screwing down the parts, ensure that the screws are neither insufficiently tightened nor over tightened.
♦ Take sufficient care to ensure safety around you when performing the assembly and installation work or while
moving about during the course of the work.
♦ Do not install the Plasma TV underneath ceiling lamps (spotlights, halogen lamps, etc.). Otherwise, the
cabinet may be bent or damaged by high heat.
[ The images shown in this manual are for illustrative
purpose only.]
Wall-hanging bracket (Adjustable angle type)
(1)
Bracket base left fitting
(1)
M8×32 Allen head
countersunk screws
Dished toothed washers
Insulation spacers
Bracket base right fitting
(1)
Spacers
(4)
(4)
M5x50 Screw for securing unit (2)
(4)
Allen wrench (included tool)
M5x10 screws
(1)
for assembling
the fixture
(4)
(4)
(1)
5 5
Advertisement
