Panasonic NH-P80S1 Operating Instructions & Installation Instructions page 23

Problem
The clogged filter warning
indicator is flashing
although none of the filters
are clogged.
The displayed remaining
time changes.
The operating sound
changes.
'0' display remains after the
programme has finished.
The lamp inside the drum
has gone out.
The lamp inside the drum
does not light up.
Drying has finished with
the Anti-crease set to OFF,
however, the Anti-crease
indicator is flashing.
The steam programme
effect is not achieved.
NH-P80S1_English.indb 23
- This is not a malfunction; the clogged filter warning
indicator flashes to alert users to clean the filters after
th
every 10 drying programme (twice a month). The
indicator may flash even if the filters have been cleaned.
- The remaining time is estimated and corrected
continually. Thus, the time displayed may change.
- This is normal; the change is caused by the on-off
conditions of the compressor and draining pump.
- This is not a malfunction; without the Anti-crease
function being set, the appliance automatically switches
itself off 2 hours after the programme finishes.
- The lamp lights up for 10 minutes when the door is
opened after the programme finishes. To activate the
lamp again, switch on the appliance, and then open the
door again.
- If 2 hours have elapsed after a programme is
completed, the lamp will not light up since the appliance
automatically switches itself off.
- For safety, the dryer cools down inside the drum. The
Anti-crease indicator flashes during this time.
- Laundry may be overloaded. (See page 15.)
- The steam pathway may be frozen.
Fault Checklist
Cause
Troubleshooting - 23
2012/11/15 14:49:17