Panasonic CY-VMC7000U Operating Instructions Manual page 20

Press [ASP] (ASPECT) on the display unit or press [A] (ASPECT) on the remote control to change the aspect
ratio as follows.
Notes:
¡This adjustment is common to VTR1 and VTR2.
¡You can not change the aspect in the menu screen and a screen in the CD mode. These are fixed to "Full".
¡The "Zoom" and "Just" screens do not apply to car navigation images.
¡When the rear view camera is in operation with the transmission gear shift in the reverse position, the image is
shown on the "Full" screen only.
¡In some cases, the picture looks different from the original one due to your selection of aspect.
Cautions:
¡This is to remind you that compression or extension of the screen using the aspect ratio (screen mode) chang-
ing function of this product for commercial purpose of profit making or viewing / listening by the public could
infringe on the rights of the author protected by the copyright law.
¡If you expand normal picture (4 to 3) by using "Just", "Zoom" or "Full" aspect to the full of the screen, you
might not see the periphery of the picture, or you might see deformed picture. Therefore, use the "Normal"
mode when you see original picture in deference to picture-making purpose.
Normal
¡The conventional display image has a 4 to 3 ratio of horizontal to
vertical.
¡In this case, a blank area remains on the right and left sides of the
display.
Full
¡The screen is extended horizontally as a whole to the aspect ratio
of 16 to 9.
¡The extension ratio is the same at any point of the screen.
Zoom
¡The screen is fully extended at the normal aspect ratio of 4 to 3.
¡The top and bottom of the screen are slightly cut.
Just
¡The screen is extended horizontally to the aspect ratio of 16 to 9.
¡The extension ratio increases toward the right and left ends of the
screen.
CY-VMC7000U
E
N
G
L
I
S
H
14
23