INDEX Delivery of the Machine Technical Description Introduction General Information Manufacturer Responsibility Intervention Request Transport Packed Machine Handling How to Unpack the machine Unpacked Machine Handling General Rules for a Machine Proper Use Preparation to Work Required Operator’s Qualities Machine Control Battery Recharge How to Check the Machine Periodical Controls...
Page 3
INTRODUCTION THIS KIND OF MACHINE ALLOWS TO DRAW, WITHOUT DIFFICULT, TROLLEYS UP TO 2500 kg. YOU CAN REACH THE BEST PERFORMANCE USING THE MACHINE IN A PROPER WAY AND TAKING CARE OF IT. USE THE MACHINE ONLY TO DRAW TROLLEYS. PLEASE, READ CAREFULLY THIS MANUAL AND KEEP IT FOR ALL NEEDS.
TECHNICAL DESCRIPTION Length 1640 mm Width 875 mm Height 1110 mm Wheels Number Wheels Diameter 400 mm. Traction electric Weight (without batteries) 296 kg. Battery Room Dimensions (LxWxH) 520x610x420 mm. Battery 4x6V – 330A Motor 36V, 2kW 2400 rpm Brake hydraulic lever Parking Brake lever...
GENERAL INFORMATION MANUFACTURER RESPONSIBILITY The manufacturer - ING. O. FIORENTINI – is not responsible for any damage due to the no-acquaintance or no- fulfilment of the instructions of this manual. The same applies to the execution of changes, modification, and/or the installation of not authorized accessories.
TRANSPORT PACKED MACHINE HANDLING The machine is packed in a case fixed on a special pallet. On the case it is indicated the gravity centre with a black arrow. The pallet must be forked in the middle of the side with the black arrow in order to avoid overturning.
GENERAL RULES FOR A MACHINE PROPER USE The vehicle is designed for one person, so do not let anybody get on the vehicle except the driver. Do not modify the machine. Drive the vehicle in a proper way and in a proper position. Drive slowly on wet surfaces.
BATTERY RECHARGE The machine is fed by a battery, which is not supplied by ING. O. FIORENTINI. On the dashboard there is a five-green-led-display that shows the battery charge level. The battery is completely low when there is only one flashing red led switched on.
- check the turn of the wheel in both directions. If one of the above test is not satisfactory, please immediately advise an ING. O. FIORENTINI technician. INACTIVITY PERIODS If the mini-tractor is not used for two or three weeks, it is necessary to disconnect the batteries, lift the tractor from the ground and place the frame on shims.
CONTROLS AND FUNCTIONING The mini-tractor controls are arranged and designed to allow a perfect machine functioning. Before using the mini-tractor for the first time, please make confident with all the controls. Read the following instructions carefully and with the key on OFF test the various controls. Steering Wheel: the steering wheel and the steering system are similar to the motor vehicle ones.
Ignition Key: the mini-tractor is Gear Selector: the forward/reverse lever equipped with a starting key on the gear selector is placed on the left of the right of the dashboard. The key is dashboard. The central OFF position is locked in the switch when it is on the neutral.
Parking Brake: it is placed on the right of the driver. The hand brake lever must be used every time the operator stops the mini- tractor. The parking brake can stop the vehicle and the load on plane surfaces or on slight slopes.
Page 14
Serial Number: Shipment Date: Distributed by: ING. O. FIORENTINI S.r.l. – Loc. Rombola 50030 Piancaldoli (FI) - Italia Telefono +39 55 8173610 – Fax +39 55 817144 E-mail: sales@ingfiorentini.it...