Picture-In-Picture Mode Monitoring - Panasonic WV-LC1710 Operating Instructions Manual

Notes:
• H-POSITION , V-POSITION
change depending on the input signal.
Normally, these parameters need not to be set.
In case the position of the picture is still shifted even
AUTO TUNING
button is pressed, operate base on the
procedure below.
1. Set the left edge of the picture to the left edge of the
monitor screen while adjusting
2. Set the right edge of the picture to the right edge of the
monitor screen while adjusting
3. Repeat steps 2 and 3 until the position of the picture is
on the center of the screen.
OSD H-POSITION OSD V-POSITION
• and
not be reset.
• Adjustment parameters from PC are not supported.

Picture-in-Picture Mode Monitoring

PIP
1. Press the button to display the subscreen in approxi-
mately 2 seconds waiting time, as shown below.
• PC Input is displayed in subscreen when Composite Video,
S-Video or Component Video inputs is displayed on main
screen of the monitor.
• VIDEO, S-VIDEO or COMPONENT is displayed in subscreen
depending on the last input done prior to switching to PC Input
when PC input is displayed on main screen of the monitor.
The input signal of subscreen displays on the upper right of
display panel.
, CLOCK and PHASE will
H-POSITION .
CLOCK
.
settings can-
VIDEO
CONNECTING WITH WJ-HD300 SERIES
• There is a possibility that the picture will be shifted if the
Monitor (VGA) terminal of the Digital Disk Recorder WJ-
HD300 series is connected to the PC input even
button is pressed. In this case, adjust
and CLOCK following the procedure indicated in upper
left note.
7. After setting the parameters, press the
Set values will be stored and the Video Adjustment Menu will
exit.
Caution:
• If power is cut off setting, it will not store the settings
that have changed.
2. After displaying the subscreen, pressing the
move the subscreen as shown below.
3
2
3. Press the INPUT SELECT
or Component input that appears on the subscreen when PC
input is currently on the main screen.
AUTO
H-POSITION
MENU button.
POS button will
4
1
button in selecting Video, S-Video,
19