Advertisement
Quick Links
Advertisement
Summary of Contents for Wirepath Surveillance Control4
- Page 1 WPS-IP Camera & Encoder Control4 Driver Installation and Setup...
- Page 2 WPS-IP Control4 Driver Setup and Configuration Table of Contents 1 Overview ..........................3 1.1 Products Covered ............................. 3 1.2 Contacting Technical Support ........................3 2 Before Beginning......................... 3 3 IP Camera/Encoder Setup ....................4 3.1 IP Camera/Encoder Connections ......................... 4 3.2 IP Camera/Encoder Network Settings ......................
-
Page 3: Contacting Technical Support
WPS-IP Control4 Driver Setup and Configuration 1 Overview The following information will guide the installer through simple set up and programming of a Control4 system to display video from Wirepath™ IP Cameras or Encoders on a Control4 interface. These instructions will work with IP cameras or encoders with any released firmware. Please read the entire document before performing any setup of the IP Camera, Encoder or the Control4 system. -
Page 4: Router Setup
Important Note for WPS-750-BUL-IP and WPS-750-DOM-IP cameras: If the Access List feature is being utilized to control which IP addresses may access the camera, the IP address of your Control4 processor must be added for streaming to work. See section 12.5.3-Access List in the camera manual for more information. - Page 5 5 Control4 System Programming The following information outlines the basic steps for configuring Wirepath™ IP Cameras or Encoders on a Control4 system. A working knowledge of the Composer Software and experience configuring Control4 is required. Do not attempt these steps without first gaining a working knowledge of Control4 system configuration.
- Page 6 130418-1523 © 2013 Wirepath™ Surveillance...