Summary of Contents for SPORTS ART A957
- Page 1 A957 OWNER'S MANUAL ASSEMBLY INSTRUCTIONS XTENSION PDF created with pdfFactory trial version www.pdffactory.com...
- Page 2 A. Introduction Guide selection pin Seat bottom Fore-and-aft adjustment Seat back Main frame Foot pad Rear cover Front top cover Side frame Front cover(A) Usage sticker Back cover Front cover (B) Selection pin (3.5 lbs / 1.5 kgs) Selection pin (6.5 lbs / 3 kgs) Cord Leg cushion...
-
Page 3: List Of Parts
B. List of Parts 1. One side frame 2. One main frame 3. One leg cushion 4. Four hexagon head bolts M10 x P1.5 x L30 for side frame and main frame 5. Four spring washers M10 for side frame and main frame 6. - Page 4 C. STEP BY STEP INSTRUCTION: 1. Hold the frames during assembly, then tighten the frames with screws provided (item 4,5,6 as listed in parts list). See Fig. 1 Fig.1 2. Tighten the leg cushion into rotator and tighten it with screws as shown in the diagram.
- Page 5 D. Operating Instruction: 1. The rotator adjusting pin is used for adjusting the rotator to the proper initial position for the user. (See Fig. 3) rotator adjusting pin Fig.3 2. The Plate adjusting pin is used for user to adjust the plate to the proper position. (See Fig.
- Page 6 3. The rotating range is shorten when rotator adjusting pin moves to "A", the rotating range is lengthen when rotator adjusting pin moves to "B". (See Fig. 5 or 5-1) Rotating range adjusting pin Fig.5 Fig.5-1 PDF created with pdfFactory trial version www.pdffactory.com...
- Page 7 4. Pull out the positioning pin to adjust the plate adjuster and the leg cushion is movable at this time. Move the leg cushion to a proper position for the user and the positioning pin gets back automatically to secure the cushion (as shown in diagram 6 or 6-1).
- Page 8 5. Pull the positioning pin out and turn it 90 degrees to either right or left direction (as shown in diagram 7 or 7-1) and the plate stays free (as illustrated in diagram 7-2). The user needs to hook the cushion by his / her ankles. Fig.7 Fig.7-1 Fig.7-2...
- Page 9 HOW TO USE THE MINOR WEIGHT STACK 1. To have a minor weight stack selection, insert the upper pin to add 3.5Lb/1.5kg or the lower pin to add 6.5Lb/3kg. 2. Pull the pin to release the minor weight stack. (See Fig. 8) Fig.8 PDF created with pdfFactory trial version www.pdffactory.com...
- Page 10 F. Belt Adjusti ng Instructi on: 1. If the belt is too tight or too loose, loosen the nut A as shown in the diagram first, then adjust the nut B, if the belt length is too long, adjust downward; if the belt length is too short, adjust upward.
-
Page 11: Usage Instruction
Usage Instruction: PDF created with pdfFactory trial version www.pdffactory.com...