Table of Contents
Advertisement
1)
Problem
The loading door is opened.
The On/Off button was not
pushed.
The Start/Pause button was not
pushed.
The appliance is in the standby
mode.
Incorrect programme selection.
The filter is clogged.
The Dry Plus function was in
minimum mode.
Unsatisfac-
The condenser is clogged.
tory drying
results.
Too high volume of the load.
The airflow grill is clogged.
Dirt on the inner surface of the
drum.
Too high water hardness.
The filter not locked in the posi-
The door
tion.
does not
The laundry is locked between
close.
the door and the seal.
You try to change the pro-
gramme or the function after
Err (Error)
the start of the cycle.
on the dis-
The function you try to activate
play.
is not applicable with the selec-
ted programme.
No drum
Defective drum light.
5)
light
Abnormally
The time to end is calculated on
elapsing
the basis of the volume and
time on the
dampness of the laundry.
)
display.
Programme
The water container is full.
inactive.
Drying cycle
Too small laundry volume.
too short.
Possible cause
Remedy
Close the loading door.
Push the On/Off button.
Push the Start/Pause button.
Push the On/Off button.
Do the selection of the applica-
2)
ble programme.
3)
Clean the filter.
Change the Dry Plus function to
the moderate or maximum
mode.
Clean the condenser.
Obey the maximum load vol-
ume.
Clean the airflow grill in the bot-
tom of the appliance.
Clean the inner surface of the
drum.
Set applicable water hardness
Put the filter in the correct posi-
tion.
Put the load correctly in the
drum.
Turn the tumble dryer off and
on. Make the new selection.
Turn the tumble dryer off and
on. Make the new selection.
Contact the service centre to re-
place the drum light.
The automatic procedure — this
is not the appliance malfunction.
Drain the water container
push the Start/Pause button.
Do the selection of time pro-
gramme.
ENGLISH
21
3)
4)
.
3)
,
Advertisement
Table of Contents
