Getting Started - Convergent Design nanoFlash User Manual

Getting Started

The nano3D is specifically designed for use with 2 cameras with SDI out in order to
•
record 3D material. It has two attached units. The top unit is the master unit and the
bottom unit is the slave unit. Each unit has all of the functionality of a nanoFlash, but
the master unit has a 3D menu for setting up a 3D record. When 3D mode is turned
"Off" on the master unit, each unit functions exactly as an independent nanoFlash unit.
It is also important to note that in 3D mode, recording can only be done in high
definition. However, both HD and SD recording can be done when 3D mode is turned
off.
Please Register your nano3D by sending a simple e-mail to "cd" – "support" – "at"
•
– "convergent-design" – ".com" with your name and the serial number off the right
side of both units of the nano3D, indicating which serial number corresponds to the top
unit, and which serial number corresponds to the bottom unit. You will get automatic
notice of firmware updates and service bulletins. Please take a moment to do this, in
order to provide a better user experience with the nano3D.
Setting up a 2D record
Make sure that 3D mode is turned "Off" on the master unit, then refer to the nanoFlash
•
manual, as the nano3D functions as two nanoFlash units when recording in 2D