Carver C43 Owner's Manual page 82

A OTP FRNM IARVTR!
The waste plate deck is not connected to the fitting and does not float. Be careful not to drop the deck plate when
removing. You can order a replacement from your Carver dealer if you do lose the plate. Waste deck plates are dropped
overboard frequently enough that we suggest you carry an extra plate in your onboard spare parts kit.
NOTITE: The waste system must be empty during storage at freezing temperatures.
WASte tAnK/GRAY WAteR tAnK DeoDoRiZeRS AnD AccePtABLe cLeAninG cHeMicALS
Any RV tank cleaner, RV anti-freeze, or RV deodorizer is acceptable for use with the waste tank or gray water tank.
oVeRBoARD DiScHARGe SYSteM
1. Open the overboard discharge seacock. The seacock is located beneath a hatch in the cockpit.
Overboard
Discharge
Seacock
2. If an optional gray water holding system is installed, turn the waste tank/gray water tank Y-valve to select the waste
tank. Otherwise, proceed to step 3. This Y-valve is located near the waste tank Y-valve.
3. Turn the ACCESSORY battery master disconnect switch to the ON position. The accessory master disconnect switch
is located on the DC control center.
4. On the DC control center, switch the DC MAIN circuit breaker ON, and then switch the FORWARD WASTE PUMP
circuit breaker ON.
5. Turn the waste pump switch ON located on the DC panel. The switch is located near the overboard discharge
seacock. This activates the overboard discharge pump, which pumps the waste overboard.
NOTITE: When the waste tank is empty, turn the overboard discharge pump switch OFF. Operating the pump when the
waste tank is empty can damage the pump.
6. After all waste is pumped overboard, turn the overboard discharge pump switch OFF.
74
S S 3 3
ection ection
4327 • X5 04/2015