Storage Areas; Glove Box; Center Overhead Console; Front Armrest Storage Area - Chevrolet Avalanche Owner's Manual

Reprogramming a Single HomeLink
Button
To program a device to HomeLink
button previously trained, follow these steps:
1. Press and hold the desired HomeLink
Do not release the button.
2. The indicator light will begin to flash after
20 seconds. While still holding the HomeLink
button, proceed with Step 2 under "Programming
®
HomeLink " shown earlier in this section.
Resetting Defaults
®
To reset HomeLink to default settings do the following:
1. Hold down the two outside buttons for about
20 seconds until the indicator light begins to flash.
2. Continue to hold both buttons until the HomeLink
indicator light turns off.
3. Release both buttons.
For questions or comments, contact HomeLink
1-800-355-3515, or on the Internet at
www.homelink.com.
®
® ®
using a HomeLink
®
button.
®
®
®
at

Storage Areas

Glove Box

Open the glove box by pulling the bottom of the handle
upward.

Center Overhead Console

Your vehicle may have an overhead console equipped
with reading lights and a small storage area.
Press the button next to the light to turn it on. Press it
again to turn it off.

Front Armrest Storage Area

Your vehicle may have a center armrest storage
compartment in the front bench seat.
To open it, fold down the armrest and press the latch
handle located at the front of the armrest. Then, let the
lid pop up and swing open.
2-57