Wood fire with ezc-031135 zero clearance cabinet and exa-10042 econair flue system (6 pages)
Summary of Contents for Ethos IS100
Page 1
ETPD0122 rev.5 Installation instructions for the Ethos IS100 wood fire with a Zero Clearance Cabinet and Econ-Air flue system Retain these instructions for future reference Page 1 of 6 Capisco Limited, PO Box 938, Whangaparaoa, Auckland 0930 - Email: sales@ethosfires.co.nz - www.ethosfires.co.nz...
Cabinet - see installation diagram for supplied ventilation plate mounting detail (page# 5). 3. Ethos insulation base panel (part# ZC1140) is required below the Zero Clearance Cabinet when in direct contact with combustible materials such as timber flooring (refer to page# 3 for further detail).
Page 3
ETPD0122 rev.5 Floor Insulation Detail The table sets out the calculated floor protector projections required to ensure that temperatures on the exposed floor comply with the requirements of the AS/NZS 2918:2001 for exposed floors constructed of medium heat resistant materials. H = Height of top of Hearth P = Projection (mm) above Exposed Floor (mm)
Page 4
ETPD0122 rev.5 The Econ-Air flue system recovers the vented heat from the Zero Clearance Cabinet and recycles it back into the stove as combustion air for added efficiency. Page 4 of 6 Capisco Limited, PO Box 938, Whangaparaoa, Auckland 0930 - Email: sales@ethosfires.co.nz - www.ethosfires.co.nz...
Page 6
ETPD0122 rev.5 Vent plates mounting detail It is essential to provide adequate ventilation to the cavity. Mount supplied ventilation plates centrally and as low as the timber frame will allow. Ensure cavity has access to uninterrupted air supply. Page 6 of 6 Capisco Limited, PO Box 938, Whangaparaoa, Auckland 0930 - Email: sales@ethosfires.co.nz - www.ethosfires.co.nz...
Need help?
Do you have a question about the IS100 and is the answer not in the manual?
Questions and answers