When The Work Is Done; Changing The Dust Bag - Bosch BBS6 series Instructions For Use Manual

en
Fold out picture pages.
Setting up
1
Figure
a) Push the hose connector into the
opening on the vacuum cleaner until it
engages.
b) To remove the hose, press the lug and
pull out the hose.
2
Figure
a) Connect the handle and the suction
hose together.
b) Connect the hand grip and telescopic
tube together.
3
Figure
Connect the floor tool and suction
pipe/telescopic tube together.
4
Figure
a) Connect the suction hoses together.
b) Disconnect the telescopic tube and
adjust its length by moving the
adjusting button/sliding sleeve in the
direction of the arrow.
10
5
Figure
Holding the power cord by the plug,
pull out the required length and plug it
into the mains socket.
6
Figure
Press the on/off button to switch your
vacuum cleaner on/off.
7
Figure
Adjust the vacuum power by turning
the power control.
Vacuuming
8
Figure
Adjusting the floor tool:
rugs and carpets =>
hard floors =>
9
Figure
Vacuuming with accessories
(attach to hand grip or suction hose
as required).
a) Crevice nozzle
For cleaning crevices and corners.
b) Upholstery nozzle
For cleaning upholstered furniture,
curtains, etc.
c) Hard-floor brush
For cleaning hard floor coverings
(tiles, parquet flooring, etc.)
10
Figure
Small accessories that you do not
need can be stored in the vacuum
cleaner lid.
en
11
Figure
When stopping cleaning for a
moment, you can use the parking aid
on the back of the vacuum cleaner.
Slide the catch on the floor tool into
the groove at the rear of the
appliance.

When the work is done

12
Figure
Unplug the vacuum cleaner.
Use the cable button to roll up the
power cord automatically.
13
Figure
To store or transport the vacuum
cleaner, use the storage aid on the
underside of the vacuum cleaner.
Stand the vacuum cleaner up on its
end. Slide the catch on the floor tool
into the groove on the underside of
the appliance.

Changing the dust bag

Replacing the dust bag
14
Figure
The dust bag change indicator in the
lid is completely yellow.
15
Figure
Open the lid by moving the locking
lever in the direction of the arrow.
16
Figure
a) Seal the dust bag by pulling the
sealing strip and then remove it.
b) Slide the new dust bag into the holder
to the stop.
!
Caution: The lid only closes with
the dust bag inserted.
If you have used the vacuum
cleaner for fine dust particles (such
as plaster or cement), clean the
motor protection filter and, if
necessary, replace it.
Changing the micro-hygienic (motor
protection) filter
(Omitted on vacuum cleaners which
have a HEPA filter).
The motor protection filter should be
changed: Each time you need to open
the replacement filter pack.
17
Figure
Open the lid.
Pull the filter holder out and open it.
Dispose of the old micro-hygiene filter
and fit a new micro-hygiene filter.
Slide the filter holder back into the
vacuum cleaner and close the lid.
11