Advertisement
Emitter Overview
1. Standard VESA connector
2. LED Red light indicator (in the shape of an X)
Using with 3D TVs and Projectors
1. Connect the emitter connector to the corresponding VESA stereo connector
in the TV or projector.
2. Once the emitter is connected to the TV/projector, please make sure that the
TV/projector is in 3D mode.
3. For maximum range emitter should not be placed on the ground/floor but
should be placed at least 10 cm above ground (like on a shelf).
The emitter does not require a battery.
Troubleshooting
The emitter is connected but the glasses still do not work: First
make sure your glasses are turned on and that the TV/projector is in 3D
mode (if the X LED on the emitter is off then the TV/projector is not in
3D mode). Also note that 3D RF glasses usually need to go through a
so called "pairing" process when using them with a new emitter for the
first time. Refer to your glasses' manual for instructions on how to pair
your glasses to a new emitter, TV or projector. If problem persists try
unplugging the emitter for a couple of seconds and then plug it back in the
corresponding VESA stereo connector in the TV/projector.
Technical Specifications
Type of Synchronization: Radio Frequency (RF)
© XPAND, All Rights Reserved.
AD025-RF-X1-manual-v2.indd 3
3D Synchronization Protocol In: VESA Stereo
3D Synchronization Protocol Out: FHD3D RF protocol
Shuttering Frequency: 96 Hz, 100 Hz, 120 Hz, 144 Hz, 192 Hz
and 240 Hz
High Frequency Rate: Yes
Connector Type: Mini-DIN 3 (VESA Stereo)
Setup: Plug&Play
Coverage Range: 25 m (82 ft) radius typical, 10 m (33 ft)
minimum (distance around the emitter)
Power: VESA powered, no external power supply needed
Operating Temperature: 5 °C (41 °F) – 40 °C (104 °F)
Weight: 76,5 g (2.69 oz)
3
www.xpand.me
7/15/2014 10:33:20 AM
Advertisement
