Advertisement
To build volume direct the airflow at the roots, against the natural
growth pattern.
USING THE THERMAL BRISTLE BRUSHES
Create large, soft, long lasting curls and increases volume and
body.
Place the brush under the hair close to the scalp. Then slowly run
to hair ends. This will give your hair perfect shape, while the bristles
and hot air create a wonderful shiny look.
When hair is almost dry, slowly run the thermal bristle brush
attachment from the scalp and move towards the ends to create lift,
volume and large soft curls.
Always ensure the air inlets are free from fluff and dust etc. The
inlet grill must be cleared of any build up of fluff or hair by using a
small dry brush. Store the appliance away from dust or moisture.
Beginning at the crown area, take a small section of hair (about 2
inches) and place the brush near the root area. Slide the hot air
styler towards the ends, then wind towards the root area.
Hold for 10-15 seconds for medium or thick hair and about 5-10
seconds for fine hair, gently unwind the hair without tension.
AFTER USING THE ATTACHMENTS.
IMPORTANT: The attachments may be hot immediately after
use. Allow the attachments to cool before removal.
REPAIRS
Do not attempt to repair the appliance yourself. Repairs can only
be made by qualified service personal with special tools. Repairs
by unauthorised persons will invalidate the guarantee, and may
result in accident or injury. If the styler fails to work properly when
purchased return it to the retailer from which it was purchased.
HOT AIR STYLER
9
Advertisement
