Advertisement
FIGURE 7
14. Install VCP cover (item 5 pg 2). Make sure that
Velcro tape adheres to cover. See Fig. 8.
FIGURE 9
11. Remove protective backing from Velcro tape and
insert VCP into mounting bracket (item 2 pg 2) as
shown in Figure 7. Make sure that holes in VCP
align with holes in bracket. Connect all wiring to
VCP per instructions included with video system.
12. Check function of all components. See operating
instruction for video system operations check. For
further assistance, refer to the video system manual
for the technical support phone number listed for
your area.
13. Install (2) two # 8 X 3/4" screws (item 1 pg 2)
which secure VCP to mounting bracket. Do not
overtighten screws. See Figure 7.
15. Install rear seat in original manner. Check seat
travel to make sure that there is no interference
with VCP. See Figure 9.
5
FIGURE 8
Advertisement
