Panasonic AJ-SDC615 Operating Instructions Manual page 51

Chapter 4 Adjustments and settings for recording
Giving a title to the selected file
4
Turn the JOG dial button to move the arrow (cursor) to
the "TITLE : " item.
#
5
When the JOG dial button is pressed, the arrow (cursor)
moves to the title input area, and the input mode is
established.
;
6
Press the JOG dial button again and turn it until the
character to be set is displayed.
When the button is turned, the character displayed is
switched in the following sequence:
Space: ∑
7
letters: A—Z
7
numbers: 0—9
7
symbols: ', >, <, /, –
7
Press the JOG dial button to enter the character.
8
Turn the JOG dial button to move the arrow (cursor) to
the next position (right), and repeat steps 6 and 7 to set
the characters (maximum of 8).
Saving the data settings to the selected file
9
When the title has been input, turn the JOG dial button to
move the arrow (cursor) to the ":" position.
;
10
When the JOG dial button is pressed, the arrow (cursor)
returns to the TITLE: item.
11
Turn the JOG dial button to move the arrow (cursor) to
the WRITE item.
12
When the JOG dial button is pressed, the following
message appears.
#
If one of the following messages appears when the JOG dial button is
pressed, the data cannot be saved.
Error message
WRITE NG NO CARD
(setup card has not been inserted)
WRITE NG FORMAT ERROR
(formatting error)
WRITE NG ERROR
(the data cannot be saved)
WRITE NG
WRITE PROTECT
Remedial action
Insert the card.
The card was formatted by a device
other than the unit.
Replace the card.
The card may be defective.
Replace it.
Remove the card to cancel write
protect.
51
4